- ページ 3

産業機器 Atlantic Boilers RS TURBOFLOW DN 32 S080+のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Atlantic Boilers RS TURBOFLOW DN 32 S080+ 18 ページ。 Plate heat exchangers

ページを印刷する

1 - GENERAL

1.1 - Preface

Your heat exchanger will give you full satisfaction

provided you maintain it well, in full, and diligently.

• Be sure to keep the following documents in a

safe place:

1) this owner's and servicing manual (supplied with

the heat exchanger);

2) the CE certificate of conformity, if necessary;

• Your plate heat exchanger has a limited range

of temperatures and pressures. As it is highly

sensitive to sudden changes in these parameters,

all precautions must be taken

to avoid operating outside the limits indicated on

the nameplate.

• Excessive temperatures will damage the gaskets

(install the appropriate safety thermostats, etc.).

• Excessive operating pressures or differential

pressures will damage the gaskets and plates

(install the appropriate safety valves, etc.).

• Plate heat exchangers are highly sensitive to

pressure surges.

Accordingly, the control must be designed to

prevent this occurring and QUARTER-TURN VALVES

MUST NOT BE INSTALLED ON ANY OF THE

CIRCUITS.

• Given the large number of gaskets, leaks

may occasionally occur. To protect against this

eventuality, install protective screens if dangerous

fluids are used or the temperatures rise to above

60°C.

• Atlantic may not be held liable for any damage

or injury resulting from failure to follow the

instructions in this manual.

• Atlantic is not liable for any consequences that

may result from the accidental mixing of the fluids

used in the heat exchanger.

1.2 - Regulations

• Official inspections: some heat exchangers

must be regularly inspected by official bodies. It

is the operator's responsibility to organise these

inspections directly with the competent

bodies. The dossier sent to our principal must

therefore be kept in a safe place.

• The heat exchanger risk category according to

the European Pressure Equipment Directive (PED)

currently in force, is indicated on the identification

nameplate.

• You must make sure that the entire system

complies with the directives and legislation in effect

in the country of operation.

• This heat exchanger must not be used for

purposes other than those stated on the order

documents. In particular, do not use fluids other

than those specified at the time of ordering.

• Scrupulously comply with the operating

conditions set out in the order documents. They

were used to determine the equipment category

set out in the European Pressure Equipment

Directive. Atlantic shall not be held liable for any or

consequential or incidental damages resulting from

failure to do so.

• Atlantic must be notified of any changes in the

operating conditions and will inform you of the

procedure to follow.

1.3 - Warranty

• The warranty is valid only if the heat exchangers

operate under the conditions for which they were

initially designed.

• The warranty can be applied only if pressures

and temperatures of the fluids can be measured

on the heat exchanger's inlets and outlets.

• Spare parts are warranted only if the storage

instructions have been followed (see the section

STORAGE). The plate pack is surrounded by a

strap (the so called warranty seal) that, if left

unbroken, is proof that the exchanger has never

been disassembled. Removing this strap, without

written authorization of the manufacturer, will

always void the warranty.

1.4 - Residual risks: damage >

cause (prevention)

POSSIBLE BODILY INJURY

• Unit tipover > Failure to follow the handling or

anchoring instructions (the unit has a very high

centre of gravity; follow the rigging instructions;

anchor the unit to the floor).

• Burns > Direct contact with the unit while in

operation or with scalding or corrosive fluids

following a leak (cut off the supply to the unit; set