ページを印刷するUnpack & inspect your Elite 8 for damage – Do not use if damaged. Check all heating elements
to make sure everything works and nothing was damaged from shipping. If damaged from
shipping do not use and contact us immediately at 602-723-2534.
Your Elite 8 has Eight (8) 120volt plug-ins for the heat elements located three (4) on each side of the Elite 8. Each heating
element is 8 amps or 960 watts. Two (2) heating elements can be plugged into a 20 amp circuit. With (4) 20 amp circuits
you can achieve full power of your Elite 8.
bottom out. Failure to do so may cause damage to the
You can use a 240 volt splitter box to use the dryer or range electrical supply. You can also use our Hotel air conditioner
splitter to power (4) of the heating elements.
. When using the Hotel air conditioner splitter do not plug one of the
Amber lights
connections from the splitter into the inlet plug-with the green light
Turning on your Elite 8:
First – Plug in internal air mover.
Disregard plugging into green light if you have the updated Elite 8 with 8 Amber lights.
element with the green light plugged in to the wall and not plugged into the Radial A/C splitter. This provides the power
to the switches and thermostat controller.
Your Elite 8 comes with a state of the art digital temperature controller built into the unit.
and requires no need for adjustment to use your Elite 8 unless you want to change the temperature settings.
Your Elite 8 comes with a state of the art digital temperature controller built into the unit.
and requires no need for adjustment to use your Elite 8 unless you want to change the temperature settings.
Elite 8
Operating Your Elite 8
Please Note: Push all plugs into the sockets on the heater until they
heater.
Disregard plugging into green light if you have the updated Elite 8 with 8
Start internal fan before taking next step. Turn Heater on.
Temperature Controller
You must have the heating
The controller is preset to 132F
The controller is preset to 132F