- ページ 7

スピーカー Atlantic Technology 44-DAのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Atlantic Technology 44-DA 8 ページ。 Dolby atmos-enabled speaker

ページを印刷する

Instruction Manual

Setting Levels

We recommend as a starting point to set the Atmos channels up to 4dB

higher than the average level of the other channels. This will help prevent

the Atmos channels from being washed out by the other channels.

As with any home theater set up the ultimate speaker placement and listen-

ing levels of your system are yours to choose. Take some time moving the

speakers around and adjusting the levels to find the best sounding experi-

ence for your system and room acoustics.

A word about amplifier power...

IMPORTANT: The power recommendation for these speaker sys-

tems assumes that you will not operate your amplifier/receiver in a

way that produces distortion. Even rugged speakers like these can

be damaged by an amplifier driven into audible distortion. The harsh

amplifier distortion ("clipping") that occurs in this situation will even-

tually cause damage to the speaker system. This type of damage may

be cumulative and can build up over time, as the amplifier is driven

into overload again and again. Such damage is easily identifiable

through examination of the damaged speaker's voice coil and is not

covered by the warranty. A complete Atlantic Technology home the-

ater speaker setup will play very loudly when provided with enough

undistorted power. If necessary, consult your dealer or Atlantic Tech-

nology for additional information.

Care of Your Speakers

Clean your 44-DA cabinets using a soft, lint-free cloth. If you wish, you can

slightly moisten the cloth with plain water. Do not use any other cleaning

agents or chemicals. Be careful not to get any water on the driver cones or

tweeter domes. The grilles may be cleaned by first removing them from the

speaker cabinet and gently vacuuming them, or by using a rolling sticky

clothes lint remover.

Avoid placing your speakers in direct sunlight or near a source of heat that

may, over time, damage the finish.

IMPORTANT: SAVE YOUR BOXES! If you can do so, save the car-

tons, packing pieces, and plastic bags that came with your speakers.

They will be useful in case you move or have to ship your loudspeak-

ers for any reason. In any case, save all packing materials until you

are certain that the systems have suffered no damage in shipment. If

you find such damage, either visible or internal, contact your dealer

immediately.

Specifications

Model

Type

Woofer

Tweeter

Frequency Response

Impedance

Crossover Frequency

Crossover Type

Recommended

Amplifier Power

Dimensions HxWxD

Weight

Finishes Available

Specifications are those in effect at the time of printing. Atlantic Technology reserves the right

to change specifications or appearance at any time without notice.

CDA is a trademark and Atlantic Technology is a registered trademark of Atlantic Technology

International. Dolby, Dolby Atmos, Dolby Surround, Dolby Pro Logic IIz, Dolby TrueHD and the

double-D symbol are trademarks of Dolby Laboratories. Specifications subject to change with-

out notice.

Setting Levels

44-DA

Sealed box, Concentric Driver Array (CDA™)

5¼" (135mm) damped polypropylene

1" (25mm) dome, silk-damped

150 Hz – 20kHz ± 3dB

6 Ohms

3.5kHz

Optimized 1st-order Butterworth

10 to 100 watts

5 ½" x 8

⁄

" x 9 ½"

141mm x 211mm x 242mm

7 lbs (3.2 kg)

Satin Black and Gloss Black