- ページ 4

スピーカー Atlantic Technology 5 LCRのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Atlantic Technology 5 LCR 4 ページ。 High performance inwall loud speaker system

ページを印刷する

System 5 LCR

Painting the Speaker Assembly

The white plastic frame of the speaker baffl e assembly and the metal grille

may be left as is, or painted to match your décor. You can paint the frame

before or after it is installed in the wall. Spray painting (using slightly thinned

paint) is the best method to use for painting the grille. After painting the

grille, use air pressure to "blow out" any grille holes that are covered over

with paint.

Speaker Connection and Assembly

Strip about 1/2" of insulation from the connecting wires. Connect them to

the appropriate push terminal, being careful to observe polarity (positive to

the red terminal, negative to the black terminal). Install the speaker baffl e as-

sembly into the previously mounted frame assembly, being careful to ensure

that the speaker wire isn't pressed up against the back of a speaker cone, and

screw it into place using the supplied screws. Again, be careful not to over-

tighten the screws. Insert the grille into the frame as outlined above, being

careful not to damage the frame or the grille's fi nish.

High Frequency Level Control

There is a switch located behind the grille on the front of the speaker. This

switch is accessible by removing the grille as outlined above. You can change

the switch setting with your fi ngernail or a small pointed object, such as a ball

point pen. The switch has three settings that adjust the high frequency output

from the speaker. We strongly recommend that you try all three settings, using

both music and movies (if the System 5 LCR is part of a home theater system).

Please note that recordings vary in their sound balance so try several differ-

ent discs. Try to achieve the best balance of natural overall sound with good

detail and clarity. The switch settings are "Normal" in the lower position,

"-2dB" in the middle position, and "+2dB" in the upper position. To aim the

tweeter, press gently on the plastic ring that surrounds the dome, but not the

dome itself. Aim the tweeter at the prime listening position when the LCR

is used as a front speaker, and away from the listening position if it's used as

a surround.

There's a "knockout" plug in the front baffl e. You can identify it by locating

the Atlantic Technology wave logo which is molded into it. If you are using

a multi-room control system, you can install a standard IR receiver in the

knockout hole.

Should you have any questions or problems please feel free to contact us at

781-762-6300 or through our web site, www.atlantictechnology.com.

System 5 Manual 2

Specifi cations

System 5 LCR (IWTS-5 LCR)

Dimensions

Cut-out Dimensions

Optimum wall volume

Drivers/Design

Frequency Response

Sensitivity

Impedance

Crossover Frequency

Companion Components

New Construction Kit

5/31/02, 1:44 PM

11"H x 8-7/16"W x 3-5/8"D

9-3/4"H x 7-1/8"W

0.5 - 1 cu. ft.

1 - 6.5" IMG woofer

1 - 1" Silk dome tweeter

52 - 20kHz ± 3dB

87dB

6 Ohms

3400Hz, 4th order Linkwitz-Riley

Subwoofer(s):

172 PBM, 272 PBM

Surround(s):

IWTS-6 or 8 CMS,

System 10e SR,174 SR

IN-NC-5