- ページ 4

除湿機 Dri-Eaz CMC100のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Dri-Eaz CMC100 6 ページ。 Dri-eaz cmc100 dehumidifier
Dri-Eaz CMC100 にも：オーナーズマニュアル (4 ページ)

ページを印刷する

MAINTENANCE

WARNING! Unplug unit before cleaning or servicing.

Note: Protect from freezing. Freezing may damage unit.

Note: Check filter one month after first installation for any initial

buildup of dust or debris, and clean as needed. See "Inspect

and Clean Filter Element" below.

MONTHLY MAINTENANCE

Inspect Power Cord

Inspect power cord for cuts, fraying or damage; do not use if

damaged.

Inspect drain hoses

Inspect drain hose for kinks, breaks, or obstructions. Make

sure the hose is draining properly.

Inspect Exterior

Inspect exterior cabinet. Make sure air vents are free of any

obstructions. Listen to the unit for abnormal sounds. For Parts

and Service, call your local distributor or the Dri-Eaz Service

Department at 800–932–3030.

Clean Exterior

Clean the housing with a damp cloth. Make sure inlet and out-

let grills are free of dust and debris.

PERIODIC MAINTENANCE

Inspect and Clean Filter Element

The CMC100 is equipped with a washable filter. Inspect the

filter by removing the four filter door screws and sliding it out of

the filter door panel (see Figure 2). If the filter shows excessive

buildup, vacuum it clean and wash it in mild detergent. Replace

the filter in the filter door and close the door securely.

Note: Do not operate the unit without the filter securely in

place. If the filter becomes torn or can no longer be adequately

cleaned, the filter may be replaced with similar cut-to-fit ma-

terial available at most hardware stores.

Fig. 4: Remove two panels for access to

pump

Interchangeable panel

07-01637F F391-A 2012-01 Warranty 07-01651

Inspect and Clean Pump

If the unit no longer pumps water out of the drain line, the

pump may be clogged with debris. Follow these steps to in-

spect and clean the pump system.

WARNING! Unplug unit before cleaning or servicing.

Tools needed

Procedure

1. Remove the interchangeable side (see Fig. 4) and set

2. Remove the two drain line panel screws and set the panel

Fig. 5: Remove the four pump bracket bolts

from the CMC drain pan.

Drain line panel

Screwdriver

Clean cloths

Coil Cleaner (Available from Dri-Eaz, product no. S402)

Vacuum cleaner with crevice tool

aside. The panel is attached with four screws.

down next to unit. The drain line is permanently attached to

the interior of the panel and to the pump assembly. DO

NOT REMOVE DRAIN LINE FROM PANEL OR FROM

PUMP.

NOTICE: RH Sensor

(behind bezel). Pro-

tect from contact with

any cleaners or disin-

fectants, as they may

damage the sensor or

cause inaccurate

readings.

Dri-Eaz Products, Inc.