- ページ 22
換気フード Electrolux HOCV11EのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Electrolux HOCV11E 28 ページ。 Built-in hood for electric and gas oven
ページを印刷する• Install ahead of the appliance a device
(interlocked plug, lockable switch or similar
devices) lockable in the open position during
maintenance;
• Connect the appliance to an efficient earthing
system. For that purpose, the connection
terminal block has a terminal with the symbol
for connecting the earth wire;
• Also, include this device in an equipotential
system (see chap. F.5.3). Make sure the oven
on which the hood is mounted has the relevant
terminal. This terminal must be in electrical
contact with all fixed exposed metal parts of
the hood and must allow the connection of a
conductor having a nominal cross-section area
of 2.5 mm2 to 6 mm2; this connection is made
with the screw marked
near the power cable entry.
Power cable installation
To connect the power cable to the appliance,
proceed as follows:
1. Open the Technical Compartment;
2. Open the the junction box on the right and
connect the cables following the instructions
below (see F.8.1 - "Power cable") and the
relevant Wiring diagram;
3. Close the Technical Compartment.
, located externally
F.8.2 Hood-oven interface cable
The hood is supplied with an Interface Cable; to
connect it, proceed as follows:
1. Remove the left side panel of the oven, as
indicated in the "Oven Installation Manual";
2. Remove the pre-cut sheet on the oven base to
obtain a 21mm hole;
3. Insert the male thread curve supplied, relevant
to the interface cable, and secure it with the
nut supplied;
4. Remove the Touch Screen Panel from the
oven, as indicated in the "Oven Installation
Manual";
5. Insert the interface cable connectors on the
relevant positions indicated X50 and X52;
6. Assemble the Touch Screen Panel on the left
side on the oven, as indicated in the "Oven
Installation Manual".
22