- ページ 6

サブウーファー Atlantic Technology IW-28 SUBのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Atlantic Technology IW-28 SUB 8 ページ。 High performance thin bezel in-wall subwoofer

ページを印刷する

Installation

• If this is new construction, we strongly recommend using

drywall. It's heavier and more expensive than ½" material, but it's far,

far superior in terms of acoustic/mechanical integrity and rigidity. We

also strongly recommend that the drywall be screwed to the studs every

6 inches or so, instead of the more common practice of nailing it every

12-18". Use screws for at least a full stud bay on either side of where the

IW-28 SUB will be mounted.

Cutting the Opening

⁄

(518mm)

⁄

(283mm)

IW-30 LCR & IW-28 SUB

IWTS-30 LCR

Mounting Template

Mount frame as shown,

with IR knockout in

upper-right corner.

Remove scrim before

painting grille.

After determining the best location for the speaker as outlined earlier, use a

level with the template to mark out the hole. Then using care, cut the proper

size hole. (11 1/8" x 20 3/8")

WARNING: Exercise extreme care before making any wall cuts to

ensure that you will not cut through any wires, pipes, or other items

that may be in the wall. You may sometimes, but not always, be able

to determine the approximate location of wires and pipes by looking

at the locations of nearby outlets and plumbing. But their location or

absence is never an assurance that there is not something within the

wall cavity.

Installing the Speaker Assembly

⁄

" or ¾"

Insert the speaker assembly into the cutout and using a level carefully align

the speaker so it is level. Loosen the mounting screws ½ turn, then tighten

them, which will cause the attached clamps to unlock, rotate and position

themselves properly behind the wall.

Continue to tighten until the frame is snug in the wall. You want the bezel to

conform to the wall surface, and the frame not to rattle from the speaker's

vibration, but be very careful not to over tighten the screws.

Painting the Speaker Assembly

holes that are filled in with paint. When the grille is dry, re-apply the scrim

cloth. You may need to use a light coat of low tack spray adhesive to hold

the scrim in place.

IW-28 SUB In-Wall Subwoofer

The clamping mecha-

nism accommodates wall

material from ½ to 1½

inches (13 to 38 mm) in

thickness. There must be

a minimum depth behind

the wall face of 3-5⁄8" (92

mm). As noted earlier,

be sure to keep the edges

of the cutout at least 1½

inches (38mm) away from

any stud or obstruction,

as the rotating clamps will

not operate properly if you

don't. There are holes in the

baffle providing access to

the rotating clamp screws

(See fig left). There is no

need to disassemble the

speaker for installation.

The white plastic frame and metal

grille may be left as is, or painted to

match your décor. You can paint the

frame before or after it is installed

in the wall. You will need to remove

the baffle from the frame before

painting. Spray painting (using

slightly thinned paint) is the best

method to use for painting the

grille. Be sure to remove the

scrim cloth before painting the

grille. Start at one corner and gen-

tly peel the scrim from the grill.

After painting the grille, use air

pressure to "blow out" any grille