- ページ 7

炉 Dri-Eaz Dragon K85 MobileのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Dri-Eaz Dragon K85 Mobile 20 ページ。 Dri-eaz dragon k85 mobile furnace owner's manual
Dri-Eaz Dragon K85 Mobile にも：オーナーズマニュアル (14 ページ)

ページを印刷する

2. Press the SET key once to access the

Fahrenheit/Celsius mode. The display will show the

current status, either F for Fahrenheit or C for

Celsius. To switch between the two, press either

arrow key. Choose either F or C.

Choose either Fahrenheit (F) or Celsius (C) mode

2. Press the SET key again to access the setpoint.

The display will blink "S1" and show the current

setpoint in degrees. The setpoint is the maximum

temperature you wish to maintain in the affected

area.

For example, with a setpoint of 85°F, the Dragon will

stop heating when the temperature exceeds 85°F.

Use the arrows to choose a setpoint.

Use the arrows to choose a setpoint

07-00407 E 08/2006

3. Press the SET key again to access the differential.

The display will blink "DIF 1" and show the current

differential. The differential is the number of degrees

the temperature will drop below the setpoint before

the Dragon begins a heating cycle. In other words,

the differential determines the minimum temperature

of the affected area.

For example, with a setpoint of 85°F and a

differential of 5, the Dragon will begin a heating

cycle when the temperature of the affected area

drops below 80°F.

Press the up or down arrow keys to select a

differential. You can select a differential from 1°F

to 30°F.

Use the arrows to select a differential

4. Press the SET key again to access the heating or

cooling mode. The display will show the current

mode, either C1 for cooling or H1 for heating. Using

the arrow keys, select H1 for the heating mode.

Important! Make sure the thermostat is set to H1 for

the heating mode. The Dragon will not function

properly with the thermostat in cooling mode.

5. Press the SET key once more to complete the

programming of the thermostat.