- ページ 8

エアコン Atlantic Ultraviolet Nutripure 5B-SCのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Atlantic Ultraviolet Nutripure 5B-SC 16 ページ。 Sanitary conditioners

ページを印刷する

Atlantic Ultraviolet Nutripure 5B-SC オーナーズマニュアル

eChniCal

ssistanCe

Atlantic Ultraviolet Corporation

may be required during the use of this equipment. For any questions, concerns, or technical assistance, regarding this model or

any of our other products, contact our application specialists. Contact options can be found in the "User Assistance" section on

the back page of this manual.

MAINTENANCE

Always disconnect power to the Nutripure

The Nutripure

•

is designed to operate with a minimal amount of maintenance.

A regular cleaning cycle of the STER-L-RAY

•

filter(s) MUST be established, and carefully maintained, based on inspection and experience. The frequency of cleaning will

vary with the conditions surrounding each installation. It is recommended that the ultraviolet lamp(s) interior, sight glass, and

filters be cleaned at least once every three (3) months.

The STER-L-RAY

•

life of 10,000 hours. STER-L-RAY

in ultraviolet output will make it impractical to use past the manufacturer's rated life. For maximum efficiency lamp

replacement is recommended every 10,000 hours of operation or about one (1) year of continuous use.

•

Unless lamp replacement is due to failure or breakage, it is recommended that all lamps be replaced at the same time.

amP

nstallation

Always disconnect power to the fixture before performing any service or maintenance.

Ultraviolet lamps are easily damaged. Exercise care when handling lamps.

Disconnect power to the sanitary conditioner and unplug from the electrical outlet.

Remove access cover. (Removal of the Nutripure

lamps and blower. DO NOT attempt to bypass or circumvent the interlock switch or its safety feature.)

3. Remove STER-L-RAY

pin clears the stationary lampholder, pull STER-L-RAY

Moisten a clean, lint-free cloth with denatured alcohol and clean lamp(s).

When STER-L-RAY

interior of the Nutripure

To remove any dust, dirt, fingerprints, smears, etc, from the outer surfaces of the conditioner, moisten a clean, lint-free cloth

with denatured alcohol and wipe down the conditioner. Buff out any streaks, left from the cleaning, using a soft dry cloth.

7. Install STER-L-RAY

the spring-loaded lampholder. Align lamp pin with stationary lampholder. Slowly ease the pressure until STER-L-RAY

lamp is fully seated in lampholders.

Verify that STER-L-RAY

Repeat until all STER-L-RAY

10. Install Access Cover. Restore power to the Nutripure

11. Wear personal protection equipment, then verify operation by viewing STER-L-RAY

operating properly, go to "Troubleshooting" section.

maintains a qualified team of application specialists that can provide technical assistance, which

Germicidal Ultraviolet lamp(s) used in the Nutripure

Lamp(s) may operate longer than their rated effective life, but the reduction

, r

ePlaCement

IN ORDER TO PERFORM THIS TASK, BE SURE TO WEAR THE FOLLOWING SAFETY

EQUIPMENT: SAFETY GLASSES OR A FACE SHIELD, AS WELL AS GLOVES.

lamp(s), carefully press lamp against the spring-loaded lampholder, when STER-L-RAY

lamp(s) have been removed, cleaned and safely set aside, remove any loose dust or dirt from the

with a soft dry cloth, or vacuum.

lamp(s), insert lamp pin into spring-loaded lampholder. Carefully press STER-L-RAY

lamp(s) is properly seated.

lamps have been cleaned and properly reinstalled.

Avoid exposure to direct or reflected germicidal ultraviolet rays. Germicidal

ultraviolet rays are harmful to the eyes and skin.

before performing any service or maintenance.

Germicidal Ultraviolet Lamp(s), interior, Promate

leaning

access cover will cause the interlock switch to interrupt power to the

lamp out, and away from Nutripure

sight glass and intake

have a manufacturer's rated average effective

lamps(s). If the fixture is not

lamp

lamp against