- ページ 37

換気フード Electrolux WHGL9040CNのPDF マニュアルをオンラインで閲覧またはダウンロードできます。Electrolux WHGL9040CN 40 ページ。
Electrolux WHGL9040CN にも：インストレーション・マニュアル (12 ページ), インストレーション・マニュアル (12 ページ), マニュアル (21 ページ)

ページを印刷する

USE

The hood can be switched on pushing directly onto the requested speed without firstly

having to select 0/1 button

Basic function

Button

Dual Function

Press briefly to turn the lighting system on and off.

Press and hold the button for 2 seconds to activate the lighting system in

"courtesy light" mode. The lights are lit at a reduced power of approximately

5W. This function can be disabled by pressing the button once again for 2

seconds or by pressing it briefly to switch to normal lighting mode.

Turns the motor off from whatever speed it is set to.

Press and hold the button for 3 seconds with all the loads turned off (Motor

and Lights), to turn the Activated Charcoal Filter alarm on/off.

Turns the motor on at speed one.

When pressed briefly, turns the motor on at speed two.

Press and hold the button for approximately 2" to turn the Delay function

on and off, that is to say to turn the appliance off after a 20 minute delay.

Suitable to complete elimination of residual odours. Can be activated

from the OFF position and from speeds 1, 2, 3. Cannot be activated with

Intensive speed On.

Turns the motor on at speed three.

Turns the motor On and Off at Intensive speed for a timed period of 5

minutes. At the end of the 5 minutes the appliance will automatically return

to the speed that was set before. If the appliance was turned off at the time

of activation, at the end of the 5 minutes the system will return to speed one.

Press and hold for 4 seconds to reset the filter alarm indicator, shown by

flashing of button T1. This procedure can only be carried out with the motor

off.

L T1 T2 T3 T4 T5 F

Indicator lights

Button off

Lights off

Button lit

Lights on

Button lit

Courtesy light on

Button lit

Motor active

Motor inactive

Button flashes twice F – Alarm On.

Button flashes once F – Alarm Off.

Button on

Speed two on

Buttons flashing

(T1+T2 or T3

Delay functionActive

or T4)

Button on

Signals the Metal Grease Filter

saturation alarm, indicating that it

is necessary to wash the filters.

Button on

The alarm is triggered after the

Hood has been in operation for

100 working hours.

When this is activated, it signals

the Activated Charcoal Filter

saturation alarm, indicating

that the filter must be changed;

the Metal Grease Filters must

Button flashing

also be washed. The Activated

Charcoal Filter saturation alarm

comes into operation after the

Hood has been working for 200

hours.

ENGLISH 37