- ページ 6
換気フード Electrolux WOGL9050CNのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Electrolux WOGL9050CN 25 ページ。
ページを印刷する
www.electrolux.com
6
4. CONTROLS
Button Function
A
B
C
D
E
F
G
H
5. LIGHTING
• For replacement contact tech-
nical support ("To purchase
contact technical support").
On/off lighting system.
Motor off.
Enables / Disables Keyboard Lock mode if pressed
and held for 5 seconds only if all loads are off.
Activates speed one.
Activates speed two.
Activates the speed Intensive 1. This speed is timed
to run for 10 minutes. At the end of this time the
system will return to the speed set previously. It
is disabled by pressing the Button or turning the
Motor off.
Activates the speed Intensive 2. This speed is timed
to run for 8 minutes. At the end of this time the system
will return to the speed set previously. It is disabled
by pressing the Button or turning the Motor off.
Activates / Deactivates Delay mode, with automatic
shutdown of the Motor and the Lighting after 15
minutes. It is disabled by pressing the button or
turning the motor off.
Pressing and holding the button for 5 seconds
enables the remote control and the H2H function.
Pressing and holding the button for 5 seconds
disables the remote control and the H2H function.
With the filter alarm triggered, press the button to
Reset the alarm. These indications are only visible
when the motor is turned off.
Press and hold the button for approximately 5 secon-
ds, with all the loads turned off (Motor and Lights),
to turn the Activated Charcoal Filter alarm on/off.
Led
-
The Leds indicating the Speed of the motor
turn off.
All the Leds light up in cycle and run a start-
up sequence.
The Leds indicating Speed one and Motor
Off turn on.
The Leds indicating Speed two and Motor
Off turn on.
The LED flashes.
The LED flashes.
The Led lights up.
2 flashes from Leds on Buttons B+C.
1 flash from Leds on Buttons B+C.
When the procedure terminates, the indication
shown previously turns off:
Led H on = Indicates the need to wash the
metal grease filters. The alarm is triggered
after the Hood has been in operation for 100
working hours.
Led H flashing = Indicates the need to change
the activated charcoal filters, and also to wash
the metal grease filters. The alarm is triggered
after the Hood has been in operation for 200
working hours.
2 flashes from Leds on Buttons B+H = A.C.
filter alarm activated.
1 flash from Leds on Buttons B+H = A.C. filter
alarm deactivated.