- ページ 4

換気フード Electrolux ZHT 510のPDF 設置・使用・メンテナンスハンドブックをオンラインで閲覧またはダウンロードできます。Electrolux ZHT 510 10 ページ。

1 - GENERAL INFORMATION

This hood has been designed to be wall-mounted above a cooking hob. It can be

installed under a wall unit or directly onto a wall. It can work either by ducting system

(external discharge) or filter (internal recirculation). Before starting the installation,

consideration should be given to the difficulties to be found during installation.

The installation work must be undertaken by a qualified and competent person

in conformity to the rules concerning the evacuation of contaminated air. The

manufacturer disclaims all liability for any damage or injury caused as a result

of not following the instructions for installation contained in the following text.

2.1 - When used in the extraction mode, the cooker hood ducting must not be connected

to a flue which is used for exhausting fumes from appliances supplied with energy

other than electric, such as a central heating flue or water heating flue.

2.2 - Before connecting to the mains supply ensure that the mains voltage corresponds

with the voltage on the rating plate inside the hood.

2.3 - Connect the cooker hood to the mains via a bipolar switch which has 3mm

clearance between the contacts.

2.4 - The device does not require earthing, as it is double-insulated.

2.5 - When installed, the hood must be positioned at least 65 cm above the hotplate.

2.6 - Never do flambé cooking under this cooker hood.

2.7 - Never leave frying pans unattended during use as overheated fat and oil may catch

fire.

2.8 - Before carrying out any kind of maintenance or cleaning, disconnect the hood from

the mains supply.

2.9 - If the room where the cooker hood is to be used contains a fuel burning appliance

such as a central heating boiler then this must be of the room sealed or balanced

flue type. If other types of flue or appliance are fitted, ensure that there is an

adequate supply of air into the room. When the cooker hood is used in conjunction

with appliances supplied with energy other than electric, the negative pressure in

the room must not exceed 0,04 mbar to prevent fumes being drawn back into the

room by the cooker hood.

The hood can be supplied with two different fixing kits:

a) screws, plugs and safety square.

b) screws, plugs and metal brackets.

Part 1 - INSTALLATION INSTRUCTIONS