Cleaning and maintenance
en
Lighting
The lighting can be switched on and off independently
of the fan.
Touch the
symbol.
B
Setting the brightness
Press and hold the
B
symbol until the required
brightness is reached.
Saturation display
If the metal grease filters or activated charcoal filter are/
is saturated, the corresponding symbols flash once the
appliance has been switched off:
Metal grease filter:
E
■
Activated charcoal filter:
■
Metal grease filter and activated charcoal filter:
■
and
F
If you have not yet done so, the metal grease filters
should now be cleaned or the activated charcoal filter
replaced. ~ "Cleaning and maintenance" on page 6
The saturation displays can be reset while they are
flashing. To do this, touch the
Switching over the display for the air circulation
mode
For air recirculation mode, the electronic controller must
be switched over accordingly:
The extractor hood must be connected and switched
■
off.
Touch and hold the
■
selector to change the display to 2. Take your finger
off the
:
symbol. This switches the electronic
controller over to air recirculation mode (filters that
cannot be regenerated).
Touch and hold the
■
selector to change the display to 3. Take your finger
off the
symbol. This switches the electronic
:
controller over to air recirculation mode (filters that
can be regenerated).
Repeatedly touching and holding the
■
changing the display to "1" switches the electronic
controller back to air extraction mode.
Audible signal
Switching on
Touch and hold the
#
time for approximately three seconds when the fan is
switched off. As confirmation, an audible signal sounds
and
is shown in the display.
‚
Switching off
Touch and hold the
#
time for approximately three seconds when the fan is
switched off. As confirmation,
6
F
or
symbol.
E
F
symbol. Use the rotary
:
symbol. Use the rotary
:
symbol and
:
and
symbols at the same
y
and
y
symbols at the same
‹
is shown in the display.
2Cleaning and maintenance
:
Warning
C l e a n i n g a n d m a i n t e n a n c e
Risk of injury!
Items placed on the appliance may overload the
fasteners, potentially causing the appliance to fall off the
wall.Do not place items on the appliance.
:
Warning
Risk of electric shock!
Penetrating moisture may result in an electric shock.
Clean the appliance using a damp cloth only. Before
cleaning, pull out the mains plug or switch off the circuit
breaker in the fuse box.
:
Warning
Risk of electric shock!
Do not use any high-pressure cleaners or steam
E
cleaners, which can result in an electric shock.
:
Warning
Risk of injury!
Components inside the appliance may have sharp
edges. Wear protective gloves.
:
Warning
Risk of injury!
If appliances supported by cables are permitted to
swing to and fro, this may overload the fasteners,
potentially causing the appliance to fall off the wall.Do
not do anything that makes the appliance swing to and
fro.
ページを印刷する