- ページ 28

掃除機 Electrolux #のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Electrolux # 38 ページ。 Over the range microwave oven
Electrolux # にも：取付説明書 (8 ページ), 取扱説明書 (20 ページ), 取扱説明書 (36 ページ), 取扱説明書 (24 ページ), レシピブック (17 ページ), 取扱説明書 (12 ページ), 取扱説明書 (20 ページ), 取扱説明書 (16 ページ), 取扱説明書 (12 ページ), 吸引マニュアル (16 ページ), ユーザーマニュアル (11 ページ), 取扱説明書 (26 ページ), 取扱説明書 (38 ページ), オーナーズマニュアル (9 ページ), 取扱説明書 (16 ページ), 取扱説明書 (16 ページ), 取付説明書 (21 ページ), オーナーズマニュアル (16 ページ), 取扱説明書 (16 ページ), サービスマニュアル (49 ページ)

ページを印刷する

Care & Cleaning

CLEANING THE BURNER GRATES, BURNER CAPS,

BURNER HEADS, SIMMER PLATE AND GRIDDLE

Surface

Burner

1st

Grate

2nd

Surface

Burner Cap

3rd

Surface

Burner Head

Electrode

To Clean the Burner Caps, Burner Heads, Burner Grates, Simmer Plate and Griddle

- Use a soap-filled scouring pad or a mild abrasive cleaner to clean the surface burner

caps and surface burner heads. The Grates, Simmer Plates and Griddle are designed to

be Dishwasher safe for cleaning. The ports (or slots) around the burner heads must be

routinely cleaned. If residue still remains in these ports, use a small-gauge wire or needle

to clean the slots or holes being careful not to damage the electrode. For proper flow of

gas and ignition of the burner—DO NOT ALLOW SPILLS, FOOD, CLEANING AGENTS

OR ANY OTHER MATERIAL TO ENTER THE GAS ORIFICE HOLDER OPENING.

ALWAYS make sure that the surface burner cap, the surface burner head and the surface

burner grate are properly in place whenever a surface burner is in use.

THE COOKTOP IS NOT REMOVABLE. Do not attempt to remove or lift the cooktop.

- Use caution when replacing the burner head so the electrode is not damaged. A damaged

electrode may cause a delayed ignition or prevent the burner from igniting

- Any additions, changes or conversions required in order for this appliance to perform

satisfactorily must be made by a qualified service technician.

The Burner Grates, Burner Caps, Burner Heads, simmer plate

and griddle should be routinely cleaned. Keeping the burner

ports clean will prevent improper ignition and an uneven

flame.

Refer to the following instructions:

To Remove and Replace the Surface Burner Grate, Surface Burner Cap

and Surface Burner Head - Remove in the following order: (1st) Surface

Burner Grate, (2nd) Surface Burner Cap, (3rd) Surface Burner Head;

18000BTU Dual Flame Burners Only (See Figure).

Reverse the procedure above to replace the Surface Burner Cap, Surface

Burner Head and Surface Burner Grate. Do not remove any burner parts

from the cooktop until the burner parts have completely cooled and are

safe to handle. Do not operate the surface burners without the Surface

Burner Caps, Surface Burner Heads and Surface Burner Grates properly

in place.

Surface Burner

Grate ( 3 )

UTION

CAUTION

UTION

Surface Burner

Caps ( 6 )

Surface Burner

Heads