- ページ 6

掃除機 Electrolux 60 - 70 SeriesのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Electrolux 60 - 70 Series 9 ページ。 Electrolux hand held vacuum cleaner owner's guide

HOW TO USE

Cleaning Accessories

3
CAUTION: Moving brush roll, power switch should
be in suction only position when using
hose.
1
Pull the hose from hose adaptor on cleaner.
2
Pull the crevice tool out of the base of the cleaner.
3
Place the crevice tool on the end of the hose.
4
When cleaning is completed, store crevice tool back
in the base of the cleaner and replace the hose in the
hose adapter on the cleaner.
6
(continued)

HOW TO MAINTAIN

The instructions given in this booklet serve as a guide to
routine maintenance. To avoid unnecessary service calls,
check the hose, dust cup and dust cup filter often. Clear a
clogged hose, empty the dust cup if it is full, and clean the
dust cup filter when it is dirty.
CAUTION: Turn off the power switch and unplug the
electrical cord before emptying the dust cup
or cleaning the dust cup filter.
CAUTION: Do not use the cleaner without the dust cup
filter properly installed. This can damage the
cleaner.
Hint: Some fine particles can restrict airflow very quickly
and will decrease performance even before the
dust container appears full. For that reason, when
vacuuming carpet fresheners or cleaners, powder,
plaster dust or similar fine substances, the dust
cup and filter may need cleaning more often.
Dust Cup and Filter
1
Pull back on the power switch to the "open cup" position
and lift dust cup away from cleaner.
Remove dust cup and empty.
2
The dust cup filter can be cleaned by brushing off over
a waste container. Do not allow to get wet.
The dust cup can be rinsed under running water and
completely dried before replacing on cleaner. We do
not recommend putting it in a dishwasher.
3
Replace dust cup filter in dust cup.
4
Put bottom edge of dust cup in cleaner as shown above
and rotate down against cleaner firmly. Dust cup latch
will automatically lock.
Open
Cup