- ページ 8

掃除機 Electrolux Beam AllianceのPDF 操作マニュアルをオンラインで閲覧またはダウンロードできます。Electrolux Beam Alliance 16 ページ。 Central vacuum system
Electrolux Beam Alliance にも：操作マニュアル (36 ページ), 操作マニュアル (13 ページ)

ページを印刷する

Secure both the 90° elbow and HEPA fi lter to the back of the power unit using the second Torx 20

screw provided.

Insert the HEPA fi lter with its two plastic tabs on the bottom of fi lter cartridge into the cavity of the

HEPA fi lter and snap into place. Close the HEPA door gently. If the door does not close easily,

remove and re-insert fi lter.

The HEPA fi lter can only be installed on the right side of the power unit and will not interfere with the

intake pipe on either side of the unit (refer to Figure 6a).

1.7 Exhaust

If the optional muffler or HEPA fi lter are not utilized and the power unit is exhausted to the outside,

the long muffler pipe adaptor must be installed directly to the exhaust pipe away from the wall. Do not

operate the vacuum vented directly into the wall as it could cause damage to the wall and/or vacuum.

See Section 1.5 for adaptor instructions.

NOTE: One elbow must be installed if the muffler or the HEPA fi lter is not used,

(refer to Figure 6b).

1.8 Optional Bag Adaptor

The optional bag adaptor is easy to install prior to placing the central vacuum unit on the wall with

the dirt bucket removed. The bag adaptor has three unique ends, each connecting to a specifi c

component.

Using the two Torx 20 screws, secure end "A" to the intake fl ange on the back inside body of the

central vacuum unit (refer to Figure 7A).

2. Secure end "B" to the Quick Clean Valve from the inside of the central vacuum unit by aligning and

locking the tabs into place (refer to Figure 7B).

Push the cardboard collar from the fi lter bag on to the open hanging end "C" of the bag adaptor

(refer to Figure 7C).

4. Reconnect the dirt bucket to the central vacuum unit and ensure the fi lter bag is completely sealed

in both the central vacuum unit and dirt bucket.

Figure 7

1.9 System Test / Operation

Be certain to comply with local electrical codes and regulations. Plug the unit into an electrical

outlet. You are now ready to check the vacuum installation:

• Be sure the dirt bucket is properly secured to the vacuum.

• Plug the hose into each inlet valve and turn on the central vacuum system with the power button

on the handle ensuring the electrical contacts operate properly.

Figure 6b