- ページ 10

サンダー Drill Master 61311のPDF 取扱説明書と安全上のご注意をオンラインで閲覧またはダウンロードできます。Drill Master 61311 12 ページ。 120 volt orbital hand sander

Maintenance and Servicing instructions

procedures not specifically explained in this manual must

be performed only by a qualified technician.

tO prEVEnt SEriOuS inJury FrOM acciDEntaL OpEratiOn:

Make sure that the Switch is in the off-position and unplug the tool from its

electrical outlet before performing any procedure in this section.

tO prEVEnt SEriOuS inJury FrOM tOOL FaiLurE:

Do not use damaged equipment. if abnormal noise or vibration

occurs, have the problem corrected before further use.

cleaning, Maintenance, and Lubrication

1. BEFOrE EacH uSE, inspect the general

condition of the tool. Check for:

• loose hardware,

• misalignment or binding of moving parts,

• cracked or broken parts,

• damaged electrical wiring, and

• any other condition that may

affect its safe operation.

pLEaSE rEaD tHE FOLLOWinG carEFuLLy

THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLY DIAGRAM

IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER OR DISTRIBUTOR

MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS

QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT, OR THAT HE OR SHE IS QUALIFIED TO REPLACE

ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR DISTRIBUTOR EXPRESSLY

STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND

LICENSED TECHNICIANS, AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY

ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS

THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO.

record product's Serial number Here:

note: if product has no serial number, record month and year of purchase instead.

note: Some parts are listed and shown for illustration purposes only,

and are not available individually as replacement parts.

Page 10

For technical questions, please call 1-888-866-5797.

2. aFtEr uSE, wipe external surfaces

of the tool with clean cloth.

3. Make sure the vents on the top are

clear of dust and debris.

WarninG! if the plug or the supply cord

of this power tool is damaged, it must be

replaced only by a qualified service technician.

Item 61311