- ページ 3

セキュリティシステム ADVANCED Network Devices IPSTROBEのPDF インストールをオンラインで閲覧またはダウンロードできます。ADVANCED Network Devices IPSTROBE 6 ページ。

Smart IP Strobe (IPSTROBE)

INSTALLATION

The strobe assembly can mount to a 4"

square junction box as follows:

1. Run Cat5 cable to the junction box,

and terminate the end, leaving

about 12" of slack inside the box.

2. Set the heads of the junction box

screws to protrude with ~1/8" of

space under each head.

3. Open the strobe assembly by

removing the two screws at either

side of the top of the box.

4. Feed the Cat5 cable through the

large 6-sided hole in the strobe box

at the bottom left (see "A" in photo).

5. Attach the strobe box to the junction

box by placing two of the diagonal

slotted holes over the protruding

screws (see "B" in photo). Tighten

the screws to firmly attach the

strobe box to the junction box.

6. Plug the Cat5 cable into the main

circuit board in the location marked

"Ethernet Cable" (see "C" in photo).

Make sure the Cat5 connector snaps into the metal connector receptacle on the circuit board,

such that it won't disconnect when gently pulled.

7. Stuff extra Cat5 cable back into the junction box cavity to minimize the amount of cable within

the strobe assembly.

8. Fold up the front of the chassis and fasten in place using the two previously removed screws that

came with the strobe assembly.

Advanced Network Devices • 3820 Ventura Dr. Arlington Hts. IL 60004

Support:

• 847-463-2237 •

www.anetdsupport.com

v2.2