- ページ 5

スピーカー Atlas PM8GDのPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Atlas PM8GD 12 ページ。 Pedant mount loudspeakers 4" and 8"
Atlas PM8GD にも：パンフレット (2 ページ), 取付説明書 (19 ページ)

ページを印刷する

PM SERIES LOUDSPEAKERS 4" AND 8"

INSTALLATION VIA MOUNTING CABLES (INCLUDED)

General considerations and hardware recommendations

CAUTION: PM series models weigh as much as 21 pounds (7.9kg) – model PM8CX. A fall from almost

any height could result in serious injury or death. Assure that the speaker is ﬁrmly mounted to an object

that can handle the weight of the PM speaker. The mounting surface the PM speaker is being attached to

should be able to handle ﬁve or more times the weight of the PM speaker

The hardware employed must be safely and securely attached both to the loudspeaker and the structure

in question, using only the mounting holes. A general rule for soft surface installations (wood beams) is to

multiply the corresponding working load limit by 75%: the result will be approximate working load strength.

Use thread locking compound for all installations.

CAUTION: Mounting the PM loudspeaker may require two people.

When in doubt contact a qualiﬁed structural/mechanical engineer for approval of the mounting

materials and methods.

1. Remove the 3 top cover mounting screws, loosen the 2 side top cover screws rotate the top

cover counterclockwise, and pull up to remove the top cover. (Fig 1 and 2)

2. Locate suitable support structure in the area the speaker is to be installed.

3. Route the bare end of the main support cable though the included clamp, then around the

mounting structure, and back through the clamp. (Fig 3 and 4)

4. Adjust the cable length in the clamp so that the eyelet end of the cable is at the ﬁnal height

above the ﬂoor. (Fig 5)

5. (For PM8) Route the eyelet end of the main support cable through the top cover of the PM

speaker, attach the included carabiner clip to the eyelet and the large mounting hole on the

back of the PM speaker. (Fig 6a) (For PM4) Route the eyelet end of the main support cable

through the top cover of the PM speaker, attach the eyelet to the large mounting hole on the

back of the PM speaker using included mounting screw. (Fig 6b)

6. Repeat steps 1-4 for the safety cable and attach it the one of the smaller mounting holes on the

support plate of the PM speaker with the included mounting screw. (Fig 6)

7. Route the speaker cable through the top cover and connect to the appropriate terminals.

8. Position the top cover over the side cover screws and rotate the cover clockwise to align the

top cover mounting screw holes. Reinstall the 3 mounting screws, tighten and tighten the side

cover screws.

9. Slide the top hole plug over the main support cable, safety cable, and speaker cable using the

opening on the side of the plug. Then slide the plug down the cable and into the top cover hole.

(Fig 7 and 8)

Note: If the speaker is being installed outdoors, seal plug with RTV silicone to prevent moisture

from entering speaker.

1601 JACK MCKAY BOULEVARD ENNIS, TEXAS 75119 U.S.A. •

INSTALLATION INSTRUCTIONS

Specifications are subject to change without notice

AtlasSound.com

Printed in U.S.A.

TELEPHONE: (800) 876-3333 • FAX: (800) 765-3435

ATS002583 RevA 02/07