- ページ 10

アンプ Atlas CP700のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Atlas CP700 16 ページ。 Commercial dual channel power amplifiers
Atlas CP700 にも：パンフレット (2 ページ), オーナーズマニュアル (16 ページ), 仕様書 (2 ページ), パンフレット＆スペック (10 ページ), オーナーズマニュアル (16 ページ), オーナーズマニュアル (16 ページ)

ページを印刷する

CP700 COMMERCIAL

POWER AMPLIFIER

Bridge Mono Configuration (Direct Coupled)

If higher power levels are required, the Atlas CP700 can be used in Bridge Mono mode, which utilizes

both channels of the amp across the speaker load.

With the CP700 turned OFF, move the rear mounted selector switch to the "Bridge" position and connect

the input signal to channel one. Connect your speaker load (4 and 8 Ohm only) across the "+" terminals of

both channels, with channel one being positive (Figure 7).

Caution! A high voltage potential exists across the two "+" speaker terminals when operating in

any Bridge Mode application!

To loudspeakers,

4 Ohm minimum

25V, 70.7V, and 100V Transformer Output Wiring

For transformer coupled operation into high impedance loads, connect your loudspeaker leads to the

barrier strip connections labeled "Audio Transformer." Connect the speaker home runs as follows:

• 25V - Connect the positive speaker lead to the terminal labeled "100" and the negative speaker

lead to the terminal labeled "70" (Figure 8).

• 70.7V - Connect the positive speaker lead to the terminal labeled "70" and the negative speaker

lead to the terminal labeled "0" (Figure 9).

• 100V - Connect the positive speaker lead to the terminal labeled "100" and the negative speaker

lead to the terminal labeled "0" (Figure 10).

• Refer to page 6 of this manual to the paragraph entitled "Calculating Constant Voltage Loads" to

determine how many transformer coupled loudspeakers you can drive with the Atlas CP700.

1601 JACK MCKAY BOULEVARD ENNIS, TEXAS 75119 U.S.A. •

CH-1

AUDIO TRANSFORMER

8, 4, and 2 Ohms

D I R . O U T P U T

BRIDGE

MONO

CH-2

AUDIO TRANSFORMER

8, 4, and 2 Ohms

D I R . O U T P U T

BRIDGE

MONO

Specifications are subject to change without notice

AtlasSound.com

Printed in U.S.A.

OWNER'S MANUAL

CH-1

100

I S O L . O U T P U T

70V

25V

- 100V +

CH-2

100

I S O L . O U T P U T

70V

25V

- 100V +

TELEPHONE: (800) 876-3333 • FAX: (800) 765-3435

ATS002102 RevC 9/05

Ensure the Stereo,

Parallel, and Bridge

Switch is set to "Bridge."

STEREO

PARALLEL

BRIDGE

Figure 7