- ページ 8

アンプ Atlas PA702のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Atlas PA702 16 ページ。 2-channel 70w power amplifier
Atlas PA702 にも：パンフレット＆スペック (10 ページ)

ATLAS SOUND PA702, 2-CHANNEL 70W POWER AMPLIFIER

Switch 2 - Sense AC / Audio

turn on trigger. Note the AC Mains Power Switch must also be in the "ON' position.

AC Trigger

- This switch function is used if you have an external device is plugged into the Unswitched AC

outlet and you want that device to turn on or activate the amplifier. The "DOWN" position of Switch 2 is for AC

trigger, meaning if a device such as a projector is plugged into the Unswitched AC outlet and is turned on the

AC trigger circuitry will sense current draw and turn on the PA702. See AC Sense control below for sensitivity

adjustments.

Audio Trigger

- This switch function is used if you have an external audio source plugged into either the RCA

or Balanced inputs and you want that audio to turn on or activate the amplifier. If Switch 2 is in the "UP" position

it is in Audio Sense mode. When audio is present at either the RCA or Balanced inputs, the trigger circuitry will

turn on the PA702. See Audio Sense control below for sensitivity adjustments.

Switch 3

- Input Mono / Stereo Switch, this switch affects both the RCA and Balanced inputs. When this switch

is in the "UP" position, only one input signal is needed to feed signal to both amplifier channels using the same

signal. Note: the input sensitivity is reduced by 6dB in the "MONO" mode. When this switch is in the "DOWN"

position, both input are separated and operate as "Stereo" mode.

Switch 4

– Hi Pass Filter In / Out, when this switch is in the "UP" position no input filter is applied. With the

switch in the "DOWN" position a 100Hz 12db Hi-Pass filter is engaged at the input of each channel.

Audio Sense Trigger Adjustment

"SENSE ON" position and Dip Switch 2 is in the "UP" or "AUDIO" position. By rotating the potentiometer

clockwise (right) the trigger point becomes less sensitive to turn on, meaning it will take more audio signal at the

input to turn on the amp. Note: Once the PA702 has sensed audio signal and has triggered on, it will take15 -20

min for it revert back into sleep mode even when there is no audio present. The PA702 level controls have no

affect on this feature.

AC Sense Trigger Adjustment

ON" position and Dip Switch 2 is in the "DOWN" or "AC" position. By rotating the potentiometer clockwise

(right) the trigger point becomes less sensitive to turn on, meaning it will take more AC Current draw from the

Unswitched AC outlet to turn on the amp. Note: When using the AC Sense mode between "STANDBY OR

SLEEP" and "ON" is instantaneous as long as the AC Sense is set properly and the component plugged into the

AC Unswitched socket is on drawing current.

1601 JACK MCKAY BOULEVARD ENNIS, TEXAS 75119 U.S.A. •

, when Switch 1 is in the "DOWN" position you may select the type of remote

- this potentiometer works when Dip Switch 1 is set to "DOWN" or

- this potentiometer works when Dip Switch 1 is set to "DOWN" or "SENSE

Specifications are subject to change without notice

AtlasSound.com

Printed in China

OWNER'S MANUAL

TELEPHONE: (800) 876-3333 • FAX: (800) 765-3435

ATS002604 RevA 03/07