- ページ 6
スピーカーシステム Atlas A-line Acoustic ELI2K-BのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Atlas A-line Acoustic ELI2K-B 12 ページ。 Small format line array system
ページを印刷するELI2K-B Line Array System
ELW110A-B Rear Panel
1. Power Switch – Turns unit power ON or OFF.
Note: There are two programs loaded into the DSP at the factory: When switching between the two programs the power on the
amplifier must be in the OFF positon.
2. Powercon Input – Connect included Powercon to 3 prong plug to this port in order to deliver electrical power to the amplifier.
3. Powercon Output – Daisy chain multiple amplified speaker systems using this output reducing number of wall plugs required.
4. PGM SEL – There are two programs loaded into the DSP at the factory. When switching between programs, follow these steps:
•
The amplifier power switch must be in the OFF positon
•
Using the PGM SEL button, press it to the IN or OUT position to make selection.
•
Turn the power button switch to the ON position and the new program selection will now be stored.
•
When switching between the two programs, repeat the previous steps. If trying to change program with the power ON,
the program will not change.
Program button IN mode is typically used for speech and acoustic music.
Program button OUT mode is typically used for prerecorded music, with a + 4db boost on the woofer cabinet.
5. MUTE CH1 & CH2 - There are two mute switches on the unit. When depressed, the channel is active and will play sound. CH1
controls the woofer and CH2 controls the line array. Press either button a second time to activate the mute function.
6. LED Indicators
PWR - Green LED indicates unit is receiving power from wall outlet.
CLIP - Yellow LED indicates that the unit is operating outside its normal range. Reduce output of source unit to avoid damaging
speakers or other components. NOTE: This unit can flash occassionally during normal use.
PROT - Red LED indicates the amplifier is in Protect mode. Do not operate the unit when the red LED is illuminated.
7. SIGNAL LED - Green LED indicates the unit is receiving signal from the source unit.
8. Volume Control - Adjusts volume of the speaker unit in reference to the master volume set at the source/mixer, 0 to -36dB.
9. Input - XLR connection delivers signal from source unit.
10. Looping Output - XLR connection delivers signal from source unit.
AtlasSound.com
9
10
2
POWERCON
NEUTRIK NAC3FCA
1601 Jack McKay Blvd. • Ennis, Texas 75119 U.S.A.
Telephone: 800.876.3333 • Fax: 800.765.3435
Specifications are subject to change without notice.
4
5
MUTE
PGM SEL
CH 1 CH 2
CLIP
MUTE
ON
PWR
VOLUME
LOOPING
INPUT
OUTPUT
ON
POWER OUTLET
12A MAXIMUM
POWER
3
– 6 –
Owner's Manual
6
PROT
7
SIGNAL
8
1
Pin 1 Array
Pin 2 Subwoofer