- ページ 11

カーアラーム Alert 750R-LCDのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Alert 750R-LCD 15 ページ。 Remote starter and security system

ページを印刷する

1. Transmitter Operation

G. temPeRAtURe CHeCK

You can monitor through the LCD screen, the present indoor temperature

of the passenger compartment before cooling or heating your vehicle.

Press the transceiver F button first, within seconds press the

button; the in-door temperature will be shown on the LCD screen. This

reading may be higher than actual ambient temperature due to the

greenhouse and is relative only the inside vehicle temperature.

H. to tURN oFF tHe Remote StARt:

When the engine is running (by remote start), if you want to stop it,

. Press button twice on the remote transmitter under remote start mode.

. Move the optional remote start enable toggle switch to OFF position. (If

installed)

. Press the brake pedal

4. Pull down the hand brake. (for Standard Transmission Gear Vehicle)

The vehicle will shut down and turn off the parking light to indicate engine stopped.

I. SHUt-DoWN INPUt FoR Remote StARteR:

If any of the following conditions exist while the system is operating, the engine will not start or

will shut down immediately:

. The hood is opened.

. The brake pedal is pressed.

. The hand brake is released (for Standard Transmission Gear Vehicle)

4. Engine is over-revved. {"Tachometer checking type" only}

5. The pre-programmed run time (5 /0 / 0 / 0 minutes) has elapsed.

✱

6. Press

button twice on the remote transmitter under remote start mode .

7. Move the optional remote start enable toggle switch to OFF position. (If installed)

8. The vehicle refused to start running after {} unsuccessful attempts.

J. DISABLING tHe Remote StARt SYStem: (If installed)

This feature allows your system's remote start unit to be temporarily disabled to prevent the

vehicle from being remote started accidentally. This feature is useful if the vehicle is being serviced

or stored in an enclosed area. To disable the remote start, move the optional remote start enable

toggle switch to the OFF position.

(·)

LCd rEmOTE TrANSCEIVEr

A. BAtteRY RePLACemeNt:

A .5V type AAA Alkaline battery powers the Remote Transceiver. When the power of the battery

weakens a

icon shall be displayed on the LCD screen. When the old battery is replaced to new

one, there will be beep sounds indicate the power is up and the clock on the LCD screen returns to

Am12:00 after displaying all the icons. Correct the time by pressing F for seconds before using

(See Timer Setting).

B. tHe Remote LCD ICoNS WItH FUNCtIoN

door Lock

Your vehicle doors are locked

Note: If the system is interfered by stronger

radio frequency around, sources of high

voltage electric power or such Obstacles like

tall buildings and so on, the transmission

range may get shorter as the system uses low

output power frequency.

Note: Press the button

two times when the

battery compartment is

empty, then insert the new

battery.

door Unlock

Your vehicle doors are unlocked

and the system is Disarmed