- ページ 6

スピーカー Bose 151のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Bose 151 12 ページ。 Environmental
Bose 151 にも：オーナーズマニュアル (19 ページ), サービスマニュアル (11 ページ)

ページを印刷する

se the cord properly

Speaker cord consists of two insulated

wires. The insulation around one wire is

striped, collared, or ribbed. This marked

wire is always positive (+). The plain wire is

always negative (–). These correspond to

the red (+) and black (–) terminals on the

back of the speaker, receiver, or amplifier.

Be sure to connect each wire to the proper

terminal (positive to positive, negative to

negative).

• Prepare the ends of each cord

At the ends of each cord, strip approxi-

mately 1/2 inch (12 mm) of insulation from

both wires. Twist the bare ends of each wire.

• Connect the cords to your speakers

At the back of your speaker, unscrew the

hex knob on one terminal post. This reveals

a small opening through the post. Insert the

bare end of one wire into the opening.

Tighten the knob to secure the wire. Now

insert the second wire into the second

terminal post (see Figure 2).

• Protect the cord

To guard against weather wear on exposed

wires, see "How to maintain Bose

speakers" on page 8.

151

Figure 2

Insert the bare wire end into the opening on the terminal post.

AM171297_09_V.pdf July 15, 2003

ake the connections

1. Connect the first cord to the left channel

of your receiver or amplifier.

a. Attach the marked wire at one end to

the red (+) terminal.

b. Attach the plain wire at that end to the

black (–) terminal.

2. Connect the other end of the same cord

to your left speaker.

a. Attach the marked wire to the red (+)

terminal post.

b. Attach the plain wire to the black (–)

terminal post.

3. Connect the second cord to the right

channel and right speaker, following the

same procedure.