- ページ 5

スピーカー Bose 301 Series VのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Bose 301 Series V 12 ページ。 Direct/reflecting speakers
Bose 301 Series V にも：オーナーズマニュアル (13 ページ), オーナーズマニュアル (12 ページ), オーナーズマニュアル (21 ページ), オーナーズマニュアル (13 ページ), オーナーズマニュアル (16 ページ), ユーザーマニュアル (10 ページ)

Choose the cord

It is important to use the proper gauge (thickness) of speaker cord.

Wire recommendations

Based on a maximum frequency response deviation of ± 0.5 dB

Gauge

Length

18 (0.82 mm

)

20 ft (6 m)

16 (1.3 mm

)

30 ft (9 m)

14 (2.1 mm

)

50 ft (15 m)

Note: Before running the speaker cord through a wall or under a ﬂoor, check your local build-

ing code requirements and safety regulations. If necessary, contact an electrical installer for

this information.

Speaker cord consists of two insulated wires. The insulation around one wire is marked

(striped, collared, or ribbed).

At the ends of each cord, strip approximately

Twist the bare end of each wire so loose strands will not touch across terminals. Be sure to

connect each wire to the proper terminal (positive to positive and negative to negative).

Note: It is sometimes difﬁcult to distinguish wire markings. Inspect both wires carefully.

AM264981_01 _V.pdf • August 13, 2002

⁄

inch (12 mm) of insulation from both wires.

Setting Up