- ページ 23

スピーカー Bose AM267565のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Bose AM267565 34 ページ。 Bose corporation user guide speaker am267565

Figure 24

Cutting along the outline

(a), and using a ﬁnger to

hold the cutout piece (b)

Insert and wire the speaker

6. Cut around three of the four sides of the outline you drew, not all the way around

(Figure 24a).

WARNING: Keep ﬁngers away from the cutting blade.

7. Hook your ﬁnger into the pilot hole and then make the ﬁnal cut (Figure 24b).

8. Using your ﬁnger, pull out the piece of wallboard you have just cut.

(a)

(b)

If you encounter insulation behind the wall

You can expect to ﬁnd insulation in an exterior wall and sometimes it appears in an interior

wall as well. If the insulation found there is malleable, you can cut it and remove some of it to

make room for the speaker. Other types of insulation will be difﬁcult or possibly dangerous to

handle.

CAUTION: Beware of hidden nails when reaching into the wall to remove insulation.

CAUTION: Wear gloves and protection for your mouth, nose, and eyes before handling

insulation that contains ﬁberglass.

Cut some insulation away from both above and below the speaker hole.

You need a Phillips-head screwdriver and optional tape to complete this step.

If your wall is not pre-wired, refer to "Planning to run speaker cord" starting on page 11. When

wire is within reach of the hole you have cut, follow the procedure below:

1. From inside the newly cut speaker hole, locate and pull out 14 inches (36 cm) or more of

the pre-wired speaker cord (Figure 25).

AM267565_01_V.pdf May 13, 2003

Steps to Installing