- ページ 28

スピーカー Bose AM267565のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Bose AM267565 34 ページ。 Bose corporation user guide speaker am267565

Steps to Installing

Secure the speaker to the wall

Figure 32

Tightening the dogleg

clamp screws

CAUTION: If you use a screw gun to tighten any screws, ﬁrst select the gun's lowest torque

setting (do not exceed 2-4 inch-pounds or 0.2-0.5 N-m of torque). If the screw does not seat

properly, ﬁnish installing the screw at the next highest torque setting, or by hand.

When the speaker is positioned inside the hole with the face straight and ﬂat against the wall,

you are ready to tighten the dogleg clamp screws, labeled WALL, along the sides of the

frame. These screws are not to be confused with the screws in each corner of the frame,

which hold the frame on the speaker face. Dogleg clamps exert pressure from inside to hold

the speaker ﬁrmly against the wall.

CAUTION: Although they should be thoroughly screwed down, be sure not to overtighten

these screws. Too much compression can crush the wallboard, making it crumble. This

creates uneven surface support and can leave gaps between the speaker face and the wall.

1. Slightly tighten the four dogleg clamp screws (Figure 32) until each one begins to grip.

This is caused by the clamps that swing out and press against the back of the wallboard.

2. With your ﬁngers grasping the frame of the speaker, rock it slightly back and forth into

position. Check for even seating of the face before you tighten the screws any further,

and adjust the speaker if it needs to be straightened.

3. When the speaker is straight, tighten each screw.

AM267565_01_V.pdf May 13, 2003

Dogleg clamp screws

Dogleg clamps