- ページ 7

屋外倉庫 ABSCO SHEDS PPCK-PTXのPDF マニュアルをオンラインで閲覧またはダウンロードできます。ABSCO SHEDS PPCK-PTX 19 ページ。 Pool pump cover

REAR PANEL ASSEMBLY

1 required

81F

Absco Industries

Assembly Instruction Manual

ABSCO POOL PUMP COVER

MODEL: PPCK-PTX

5' W x 5' D x 4' 10" H

PPB

- This completes the rear panel -

FAST001

81F

Model: PPCK-PTX

1. Layout and overlap two PPB

sheets by one rib as shown.

You'll need to turn one 180

degrees.

Align them so the two rib holes

overlap and the edge holes are

to the outsides.

2. Fasten with 3/8" self tapping

screws through prepunched

sheet-to-sheet holes on overlap.

If you can't see bottom hole twist

the sheet left or right.

Make a new hole with supplied

drill bit if bottom hole is too far

up or down the sheet or not

found.

3. Attach the top and bottom

channels using the SNAP-TiTE

method.

Make sure you have the short

side of the channel to the

outside of the sheeting

27/4/23

1.0