- ページ 27

スピーカー Bose L1 Model IのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Bose L1 Model I 32 ページ。 Troubleshooting
Bose L1 Model I にも：クイック・セットアップ・マニュアル (2 ページ), トラブルシューティング (2 ページ)

Figure 9

Using a parallel effects

connection

Using parallel effects connection with the L1 model I power stand

Note: Connecting an effects unit in parallel requires one ¼-inch unbalanced (instrument) cable,

one mono ¼-inch phone (M) to dual mono ¼-inch phone (F) "Y" cable adaptor, and one TRS split

"insert" cable (with a ¼-inch TRS connector on one side and two mono ¼-inch phone connec-

tors on the other).

1. Insert the TRS plug into the Channel 1 Insert jack on the L1 model I power stand.

2. Connect both ¼-inch plugs from the "insert" cable into both receptacles on the "Y" cable

adaptor.

3. Connect the plug of the "Y" cable adapter into the input of the effects processor.

4. Connect the ¼-inch unbalanced (instrument) cable from the output of the effects

processor to Channel 3 Line IN of the L1 model I power stand.

5. Set the effects level of the processor to full and turn the mix level of the effects processor

to full "wet".

6. Adjust the Channel 3 Level control of the L1 model I power stand for the desirable

effects mix.

Connect to

Channel 1 Insert

L1 model I power stand

TRS split "insert" cable

1/4-inch Instrument Cable

Connect to Effects

Unit OUTPUT

Connect to

Channel 3 Line IN

PERATING

Mono 1/4-inch Phone (M) to

dual mono 1/4-inch Phone (F)

"Y" cable adaptor

Connect to Effect Unit INPUT

Digital Effects Unit

NSTRUCTIONS