- ページ 14
ドリル Atlas Copco PHE 6 SのPDF 修理指示をオンラインで閲覧またはダウンロードできます。Atlas Copco PHE 6 S 18 ページ。
ページを印刷する1
PHE 6 S:
Press the buffer (1) into the spindle
Assembling the
sleeve (9) using a mandrel. Mind the
spindle sleeve
right position!
2
Fit the O-rings (2) to the anvil (3) and in-
sert the anvil into the spindle sleeve (9).
3
Insert the following parts into the spindle
sleeve (9):
- recoil ring (4),
- rubber ring (5),
- retainer (6),
- O-ring (7) and
- spring ring (8).
1
PHE 6 S:
Push the spring (F), the washer (6) and
Mounting the
the bearing (B) as well as the O-ring (7)
guide sleeve and
over the cylinder (E).
the spindle
2
Fit the guide sleeve (8) with the O-ring (9)
and fasten it with the secured screws (A).
3
4
Push the ball bearing (5) over the spindle
sleeve (G) and secure it with the spring
ring (4).
5
Insert the complete spindle into the hous-
ing.
6
Press the rotary shaft seal (3) into the
nosepiece (2).
7
Fix the machine into a vice provided with
protective chops and fit the nosepiece (2).
Fasten the nosepiece with a torque of
120 Nm.
8
Mount the plastic housing (1).
9
Fit the back part of the housing (D) and
fasten it with the screws (C).
When mounting the spring ring (8) take
care that it engages in the groove of
the spindle sleeve.
Take care that the spring (F) is located
centrally on the cylinder (E) (see illus-
tration).
Attention: The nosepiece (2) has a left-
handed thread!
Repair Instructions No.181.03/98
1
2
1
G
PHE 6 H / PHE 6 S
7
4 5
6
3
9
4
5
2
3
8
7
9
B
A
F
E
D
PAGE
13
8
7
6
C
8