- ページ 3

ツール Atlas Copco 4210 4480 74のPDF 指導補足をオンラインで閲覧またはダウンロードできます。Atlas Copco 4210 4480 74 8 ページ。 Reaction bar

Reaction bar

Instruction Supplement

Installing the reaction bar

Attach the reaction bar to the tool and insert the retaining ring into the groove to hold the

reaction bar in place.

Attach the socket to the square drive. Make sure to insert the locking pin through the

socket and square drive according to the illustration.

Operating the tool with reaction bar

Attach the tool to the application.

WARNING Be aware that the reaction bar will turn in the opposite direction to

the tool.

By using the reverse lever, the tool can be operated in both clockwise and counter-clock-

wise directions.

Make sure the tool is placed in the correct position on the work surface as described in the

picture. The end surface of the reaction bar and the socket/nut must be aligned. Make sure

that the foot of the reaction bar hits the center of the nut that takes the reaction force.

WARNING Never put your hand on or close to the reaction bar while the tool is

being used.

Press the push button to start the tool.

Continue pressing the push button while running down the nut. With pneumatic tools you

can hear a sound, while the tool is running the nut down. When the sound decreases, re-

lease the push button to stop the tool. With electric tools the run down of the nut is con-

trolled by the Power Focus.

Instruction Supplement