- ページ 7

スピーカーシステム Bose 301 Series VのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Bose 301 Series V 12 ページ。 Direct/reflecting speakers
Bose 301 Series V にも：オーナーズマニュアル (13 ページ), オーナーズマニュアル (12 ページ), オーナーズマニュアル (21 ページ), オーナーズマニュアル (13 ページ), オーナーズマニュアル (16 ページ), ユーザーマニュアル (10 ページ)

Check the connections

Check to be sure all connections are made positive to positive (+ to +) and negative to

negative (– to –) (Figure 4). Make sure that no loose strands of wire touch across terminals.

Bridged wires can short circuit and damage the amplifier. Tighten any loose connections

before you plug in the receiver and turn it on.

Back of RIGHT speaker

To make sure your speakers operate correctly:

1. Place the speakers less than 6 inches (15 cm) apart, facing each other.

2. Turn on your receiver. Set the receiver to MONO (monophonic), if that is an option on

your receiver.

3. Make sure that all special effects (such as surround sound) are turned off.

4. Set the balance control to normal (center position).

5. Play some deep bass passages of music through the speaker.

The sound should seem to come from a point between the two speakers. The bass should

be full and natural. If it is not, one of the connections may be reversed, causing the speakers

to play out of phase (refer to "Make the connections" on page 6).

To correct the problem, make sure all the wires are connected positive to positive (+ to +)

and negative to negative (– to –). Then repeat steps 1 through 5 above to re-test

the speakers.

AM181869_04_V.pdf

+ -

– +

+ –

Back of receiver

Back of LEFT speaker

+ -

October 30, 2001

Setting Up

Figure 4

Completed connections