- ページ 10

スピーカーシステム Bose 901のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Bose 901 20 ページ。 Vi direct/reflecting speaker system
Bose 901 にも: オーナーズマニュアル (41 ページ), オーナーズマニュアル (23 ページ), 組立・取付説明書 (1 ページ), オーナーズマニュアル (12 ページ), 設置および操作マニュアル (15 ページ)

Bose 901 オーナーズマニュアル
Connecting to the tape monitor
connection
Removing horseshoe pins
10
3. Connect one end of a cable to the AMPLIFIER INPUT jacks on the 901
a. Insert the first connector firmly into the INPUT jack marked R.
b. Insert the second connector into the INPUT jack marked L.
4. Connect the other end of the cable to the OUT or RECORD jacks on your receiver. These
jacks may be marked TO INPUT, FROM INPUT, or REC.
a. Insert the first connector into the OUT or RECORD jack marked R.
b. Insert the second connector into the OUT or RECORD jack marked L.
5. Connect the second cable from the AMPLIFIER OUTPUT jacks on the 901 active equalizer
to the IN or TAPE jacks on your receiver. These jacks may be marked PLAY, TO OUTPUT,
FROM OUTPUT, or MONITOR.
6. Plug the power cord of the 901 active equalizer into one of the switched outlets on the
receiver so that it will be powered when the receiver is switched on.
Use these instructions:
• for stereo-only operation if your receiver does not have a TAPE MONITOR connection.
• if you are using a surround sound receiver that has a section on the back marked PRE AMP
OUT/MAIN AMP IN. The jacks may be labeled ADAPTER or SIGNAL PROCESSOR.
If your receiver does not have this PRE AMP OUT/MAIN AMP IN section, the 901
speakers will not be usable in your home theater system.
1. The PRE AMP OUT/MAIN AMP IN jacks on your receiver are usually connected by small
bars called horseshoe pins. Remove these pins. See Figure 6.
Amplifier or Receiver
PRE
MAIN
AMP
AMP
OUT
IN
L
L
R
R
®
active equalizer.