- ページ 8

テント ABSCO SHEDS CPSW41のPDF マニュアルをオンラインで閲覧またはダウンロードできます。ABSCO SHEDS CPSW41 18 ページ。 Skillion carport

STEP 3.

MARK A LINE 1355 IN FROM EACH END OF BOTH EDGE (SIDE) BEAMS. THESE ARE THE

POSITIONS FOR LOCATING THE COLUMN TOP BRACKETS, TO WHICH THE COLUMNS AND

CROSS BEAMS WILL BE LATER CONNECTED.

REAR

THE REAR RHS COLUMNS ARE 50mm SHORTER THAN THE FRONT RHS COLUMNS. THIS

PRODUCES ABOUT A ONE DEGREE FALL IN THE ROOF, TO ALLOW RAINWATER TO FLOW TO

THE REAR DOWNPIPE.

THEREFORE, TO ENSURE THAT THE COLUMNS WILL REMAIN VERTICAL WHEN THE

STRUCTURE IS RAISED, EACH COLUMN TOP BRACKET MUST BE OFFSET BY 6mm AS

SHOWN BELOW. YOU CAN SEE BELOW HOW THE END RESULT WILL KEEP THE COLUMNS

VERTICAL BUT TILT THE ROOF.

REAR

MARK THE HOLE POSITIONS FOR THE FOUR HOLES TO BE DRILLED IN THE BEAMS AT EACH

LOCATION, AND DRILL 10mm HOLES. DO NOT FASTEN THE COLUMN TOP BRACKETS TO THE

EDGE BEAMS AT THIS STAGE.

ABSCO INDUSTRIES

Skillion Carport Model: CPSW33-41

FLUSH WITH INSIDE

FLANGE AT THIS POINT

ASSEMBLY INSTRUCTION MANUAL

Absco Industries

SIDE

CARPORT MODEL: CPSW33-41

THIS SET OF FOUR

HOLES MUST MATCH

THE FOUR HOLES IN THE

CROSS BEAM.

FRONT

FLUSH WITH INSIDE

FLANGE AT THIS POINT

FRONT

10-05-2018

PAGE 08