- ページ 14

エアクリーナー Advanced Radiant Systems Cool-Space CSW-12-VDのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Advanced Radiant Systems Cool-Space CSW-12-VD 19 ページ。

ページを印刷する

ELECTRICAL SHOCK HAZARD

Serious injury or death may

•

occur.

Disconnect from electrical

•

supply before servicing this

product.

Fan System:

The fan system consists of two primary elements: Fan Blade and Motor

Problem

Fan won't run and makes no sound.

Fan motor won't run and makes a

humming sound.

Breaker trips or fuse blows when fan is

started.

Motor overheating and shutting off.

Restarting several minutes later.

Fan motor won't run and switch makes

soft clicking sound.

Water Systems:

The water delivery system consists of four primary elements: Water Hose, Float Assembly, Pump,

and Water Distribution Channel.

Problem

Floor at side of the unit is wet.

The unit overflows from reservoir.

Water leaking from drain valve.

Too many dry streaks in the pads.

Water spitting from the unit.

Pump motor will not run when switch

is turned on.

Page 13 of 16

TROUBLESHOOTING

Check

Power cord, extension cord, switches, and circuit

breaker.

Motor stalled (will not turn by hand).

Motor stall.

Check power source for min. 115v/10 amp.

Extension cord adequacy.

Extension cord gauge too small.

Inlet air obstructed or too close to wall.

Faulty motor.

Switch making good contact.

Check

Water inlet hose is loose at supply

hose.

Float valve hose is loose at bulkhead

fitting or at float valve.

Water pressure is too high to allow

float valve to shutoff (60psi max).

Float valve is not seating properly.

Make sure drain nut is secure.

Holes in water distribution tray are

blocked.

Hose connection loose.

Check switch, cord and circuit

breakers.

Solution

Reconnect power or extension cord.

Reset breaker.

Replace motor.

Upgrade power supply.

Replace with heavier cord.

Provide additional inlet clearance.

Replace motor.

Replace switch.

Solution

Tighten connections and/or replace

hose washers.

Tighten connections and/or replace

hose washers.

Reduce water pressure by adding an

inline pressure reducer.

Check float valve.

Replace float

Tighten drain nut.

Remove distribution tray and clean

Tighten hose.

Replace hose and washer.

Replace switch and reset breaker.