- ページ 2
浄水器 3M SGLP200-CL-BPのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。3M SGLP200-CL-BP 17 ページ。 Reverse osmosis filtration systems
3M SGLP200-CL-BP にも： 据付・取扱説明書 (17 ページ)
ページを印刷する
Intended Use Statement:
SGLP100-CL, SGLP200-CL, SGLP100-CL-BP and SGLP200-CL-BP are intended for use
in filtering potable water and have not been evaluated for other uses. The products are
installed at the point of use and must be installed as specified in the installation instruction
by a qualified professional.
WARNING
Read entire manual. Failure to follow all guides and rules could cause personal injury or
property damage.
•
Check with your local public works department for plumbing codes. You must follow
their guidelines as you install the Water Filtration system.
•
Your Water Filtration system will withstand up to 125 pounds per square inch (psi) water
pressure. If your water supply pressure is higher than 80 psi, install a pressure reducing
valve before installing the Water Filtration system.
To reduce the risk associated with choking:
•
DO NOT allow children under 3 years of age to have access to small parts during the
installation of this product.
To reduce the risk associated with the ingestion of contaminants:
•
DO NOT use with water that is microbiologically unsafe or of unknown quality without
adequate disinfection before or after the system.
To reduce the risk associated with hazardous voltage due to an installer drilling through
existing electric wiring or water pipes in the area of installation:
•
DO NOT install near electric wiring or piping which may be in path of a drilling tool
when selecting the position to mount the filter bracket.
NOTICE
To reduce the risk associated with property damage due to water leakage or flooding:
• Read and follow Use Instructions before installation and use of this system.
• Change the disposable pre-filter at the recommended interval; the disposable pre-filter
MUST be replaced every 12 months or sooner.
• Change the disposable filter RO membrane at the recommended interval; the disposable
filter RO membrane MUST be replaced every 24 months or sooner.
• Failure to replace the disposable pre-filter and disposable RO membrane at
recommended intervals may lead to reduced filter performance and failure of the filter,
causing property damage from water leakage or flooding.
• Installation and use MUST comply with all state and local plumbing codes.
• Protect from freezing, remove filter cartridge when temperatures are expected to drop
below 33°F (4.4°C).
• DO NOT install systems in areas where ambient temperatures may go above 110°F
(43.3°C).
• DO NOT install on hot water supply lines. The maximum operating water temperature of
this filter system is 100°F (37.8°C).
• DO NOT install if water pressure exceeds 125 psi (862 kPa). If your water pressure
exceeds 80 psi (552 kPa), you must install a pressure limiting valve. Contact a plumbing
professional if you are uncertain how to check your water pressure.
• DO NOT install where water hammer conditions may occur. If water hammer conditions
exist you must install a water hammer arrester. Contact a plumbing professional if you are
uncertain how to check for this condition.
• Where a backflow prevention device is installed on a water system, a device
for controlling pressure due to thermal expansion MUST be installed. Contact a
plumbing professional if you are uncertain how to select/install/maintain a thermal
expansion device.
1