- ページ 5

テント 23zero PANTHERのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。23zero PANTHER 16 ページ。 Change room annex
23zero PANTHER にも：ユーザーマニュアル (7 ページ)

PANTHER USER MANUAL

Fitting to roof rack

The PANTHER roof top tent must be fitted to roof racks with hinges facing left hand side of vehicle

(AUS passenger side). It will open over the right hand side (AUS driver's side). Clamp 4 corners

using 8 x 45mm M8 Bolts with slides & 4 x mounting plates supplied.

Lift roof top tent on top of the vehicle's roof rack (minimum 4-person lift).

Important: Ensure the PANTHER is closed and locked in position..

Slide 4 x 45mm M8 Bolts with slides into each bottom mounting rail. Position these so there are

2 bolts toward the front of the tent and 2 bolts toward the rear of the tent on each rail. Lift / tilt the

roof top tent to allow the inner bolts to cross over onto the inside of the roof bars.

Inspect the position of the roof top tent to ensure it will open in the desired position.

Place a mounting plate under the roof bar whilst locating the bolts and hand tighten Nylok nut.

Repeat for all 4 corners. Double check the tent's position as desired and tighten all nuts securely

with 13mm spanner. Insert end caps into the ends of the mounting rails, this may require light taps

with a hammer.

Inspections: Roof top tents have many moving parts so maintenance checks are always advised.

During trips regularly check that all the above fixings are tight and in good repair.