メディア・コンバーター Bose Acoustic Wave Series IIのPDF マニュアルをオンラインで閲覧またはダウンロードできます。Bose Acoustic Wave Series II 2 ページ。 4x4 mic/line input/output card
Bose Acoustic Wave Series II にも：オーナーズマニュアル (20 ページ), オーナーズマニュアル (20 ページ), インストール (3 ページ), マニュアル (46 ページ)

ページを印刷する

Installation should only be performed by trained service personnel.

1. Turn off and unplug the ESP-88 and detach the top cover by removing the

8 screws.

2. Remove two brackets from adjacent empty slots from slots 5-8 by removing

the four screws, two from each bracket (save these screws). The 4x4 mic/line

input/output card will replace these brackets.

Note: The 4x4 mic/line input/output card occupies 2 adjacent slots. The main

card must be inserted into an odd numbered slot (1, 3, 5 or 7).

3. Attach the free side of ribbon wire from the 4x4 Out module to the larger

input card's connector.

4. Position the card in the chassis. Be sure to align the card's LEDs with the

holes in front of the chassis, and make sure the connector on the side

of the card is aligned with the connector on the motherboard. Use the black

guide on the bottom of the case to direct the card using the grooves.

See Figure 1.

5. When the connector on the card is aligned above the connector on the

motherboard, press gently to mate the connectors.

6. Screw both parts of card into place.

7. Fasten the LED PCB to the front of the chassis with the screw included with

the card.

8. Reattach the top cover and fasten the 8 screws. Plug in the power supply

and turn on the ESP-88.

9. Use the ControlSpace™ designer software to verify the card was inserted

correctly:

a) Press scan and confirm that the software detects the card.

b) If the card was installed correctly, right-clicking the ESP-88 and

displaying its properties will show 4x4 Mic/Line II in the correct slot in

the ESP-88. See Figure 2.

10. If an error message appears, or the software does not properly detect the

4x4 mic/line input/output card, repeat the installation instructions. Be sure

that the card is completely pushed into the motherboard connector, and that

the card is properly aligned in the chassis.

For installation instructions in other languages, please visit pro.bose.com.

ControlSpace

ESP-88 4x4 mic/line input/output card series II

™

Figure 1

Figure 2

CAUTION: ESD sensitive device. Handle with care.