Connecting Other Equipment
Using the AUx IN connector
When using a TV, DVD player, computer, video game or other audio
source, you can enhance your listening experience by playing the
audio device through your Wave
Connecting an audio device to your Wave
system requires one of the following cables:
Male-to-male 3.5 mm stereo cable
Dual RCA male to 3.5 mm male stereo cable
To obtain the correct cable, contact Bose
visit a local electronics store. See the contact information sheet
included in the shipping carton.
To connect an audio device, such as your TV, to the system:
1.
Connect one end of the stereo cable to the output of the audio
device.
2.
Connect the other end of the cable to the AUx IN connector
on the rear panel of your Wave
3.
Press
on the remote control.
The last source you were listening to will be active.
4.
Press
once or twice to select the AUX input.
The AUx source indicator should be displayed.
Note: If an audio device is plugged into AUx IN, pressing
will toggle between SoundTouch™ and the
audio device.
5.
Press and hold
or
Note: If the volume level of your Wave
system cannot be adjusted high enough, increase the
volume level of the connected audio device.
20 - English
SoundTouch™ music system.
®
SoundTouch™ music
®
customer service or
®
AUx IN
Dual RCA to 3.5mm
stereo cable
SoundTouch™ music system.
®
to adjust the volume.
SoundTouch™ music
®
Using headphones
For private listening, plug the headphones into the headphone
connector on the rear panel of the Wave
system.
Note: The system speakers are automatically muted when you
plug in your headphones.
CAUTION: Long-term exposure to loud music may cause hearing
damage. It is best to avoid extreme volume when using head-
phones, especially for extended periods.
Note: The system speakers are automatically muted when you
plug in your headphones. The speakers will automatically
unmute when you disconnect the headphones. Because
headphone volume levels may vary from speaker vol-
ume levels, be sure to lower the volume of the Wave
SoundTouch™ music system before connecting or
disconnecting headphones.
Note: If an alarm sounds while using headphones, it will sound
through the system speakers.
To change the headphones volume:
Press and hold
or
to adjust the listening level of your
headphones.
SoundTouch™ music
®
HEADPHONES connector
HEADPHONES cable
(Headphones not included)
®
ページを印刷する