- ページ 13

アンプ Bose M277296_01_PAS_UKEvoのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Bose M277296_01_PAS_UKEvo 28 ページ。

ページを印刷する
Bose M277296_01_PAS_UKEvo オーナーズマニュアル
Setup
Figure 7
Installation of two B1 bass
modules
13

Connecting two B1 bass modules

Connect the first B1 bass module to the PS1 power stand as shown in "Connecting one B1
bass module."
Insert one end of the second B1 bass module cable into the unused jack on the rear panel of
the first B1 bass module. Insert the other end of the cable into one of the jacks on the rear
panel of the second B1 bass module.
CAUTION: Do not connect more than two B1 bass modules to the B1 Bass Module (Amp 3
OUT) jack on the PS1 power stand. Driving more than two B1 bass modules from the B1 Bass
Module (Amp 3 OUT) output will improperly load the amplifier in the PS1 power stand resulting
in poor system performance.
Note: Use only the supplied (blue) B1 bass module 4-wire cable to connect B1 bass modules
to the PS1 power stand. The PS1 power stand uses the signals on two of the four wires to
automatically sense how many B1 bass modules are connected to it. DO NOT SUBSTITUTE
the supplied cable with a 2-wire speaker cable.
To
B1 Bass Module
(Amp 3 OUT)