- ページ 12

ヘッドセット Bose Aviation Headset XのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Bose Aviation Headset X 36 ページ。 Owner's guide
Bose Aviation Headset X にも: オーナーズマニュアル (36 ページ), クイック・セットアップ・マニュアル (1 ページ), オーナーズマニュアル (16 ページ), オーナーズマニュアル (36 ページ)

Bose Aviation Headset X オーナーズマニュアル
G
Y
H
ETTING
OUR
EADSET
Figure 7
Positioning the mic cable
assembly on the preferred
earcup
Figure 8
Moving the clothing clip
along the cable
12
R
U
EADY FOR
SE
Access
cover
Connector
pins
4. Press the assembly onto the connector pins until it is fully
engaged and the cable assembly is flush with the earcup.
CAUTION: Do not apply excessive force, which may result in earcup dam-
age.
5. With the screw threads properly aligned, tighten the screws.
6. Rotate the microphone boom into position so it will be near your
mouth when you put on the headset. The label should be facing
your lips.
7. Attach the access cover to the connector panel on the earcup
that does not have the boom mic attached. Align the screws and
tighten them to secure the cover.
• If you moved the boom mic from one earcup to the other, reuse
the access cover you removed earlier.
CAUTION: Be sure to try the headset and test its operation before flight.

Clothing clip

Use the clothing clip (Figure 8) for attaching the control module to
your clothing, a safety harness, or an aircraft door pocket. Pressing
on the end of the clip allows you to reposition it along the cable.
CAUTION: Do not attempt to clip onto surfaces that are more than
-inch thick.
1
/
4
Connector
Cable
pins
assembly
Press to release
L for left