- ページ 2

ウィンドウ・ブラインド 247Blinds SkylightのPDF 取付説明書をオンラインで閲覧またはダウンロードできます。247Blinds Skylight 2 ページ。

Step 3
Remove the red cord retainers and unwind the cord. These can be disposed of. Pull the cord to the bottom of the side
channel and secure in to the locking mechanism. Trim any excess cord to 1.5cm out of the locking mechanism – make
sure that the blind works correctly before trimming any excess cord.
Troubleshooting/Re-Tensioning
The blind is supplied pre-tensioned and should work correctly once fitted. If you would like to adjust this, please adjust
as follows;
If the blind does not stay in position or raises on it's own accord, you can add additional tension to the cords by moving
the cord stops higher on each side channel.
If the blind is difficult to raise or lower then there is too much tension on the cord. Just lower the position of the cord
stops on the cord on each side channel.
If the bottom bar does sit level, then reduce the tension only on the side that sits lowest.
Optional
For larger windows (size 04 or bigger recommended), you may wish to secure further using 2
normal screws, positioned through the side channels in to the window frame.