ページを印刷するModell 160/161
Assembly:
Place the pre-assembled trestle components as illustrated on an even surface, ensu-
ring that the flat-head recesses to accommodate the washer and bolt unit are pointing
towards the outside. Guide the two lower tension screws through the provided
boreholes (see illustration) and mount the washer and nut unit on each side
(wait before tightening).
Then place the cross beams on the already fixed tension screws. It is important to
make sure that the tension screws slot into the provided grooves. Now the two upper
tension screws can be inserted and tightened.
(For mounting an ANKE pull-out compartment, please use the supplied mounting instructions)
Dimensions
in mm
4
The solid carpenter's bench trestle made of best quality red beech provides the
guarantee of safe and vibration-damped working. To maximize stability, the trestle
is assembled using high-grade mortise and tenon joints.
tail vice
View from
below
View from above
Readjustment: Using two countersunk screws on the underneath,
countersunk head screw
The bench top is permanently fixed to the trestle
using four 6x80 countersunk head Spax screws.
Drill holes have been prepared for this in the
factory on the underneath of the bench top.
To assemble, simply place the bench top on the
trestle, align the top as shown in the sketch on
the left and screw four countersunk head Spax
screws into the top from below.
the guide can be readjusted depending on the degree
of wear to restore freedom from backlash.
At regular intervals, clean dust deposits from
the threaded spindles of the front and tail vice
and re-oil.