- ページ 3

水ポンプ DROPSA 3414046のPDF ユーザー・メンテナンス・マニュアルをオンラインで閲覧またはダウンロードできます。DROPSA 3414046 10 ページ。 Pneumatic-driven pump

5. PUMP COMPONENTS

5.1 Example of a pneumatic-driven pump Series 3414...

6.1 UNPACKING

Once a suitable location has been found to install the unit remove the pump from the packaging. Check the pump has not

been damaged during transportation or storage. No particular disposal procedures are necessary, however packing

should be disposed of in accordance with regulations that may be in force in your area or state.

6.2 INSTALLING THE PUMP

No particular assembly operations are provided.

Pump must be fixed to floor. On this purpose, pump bracket has been provided with 4 holes, Ø 8.5 mm (0.33 in). Then,

pump must be pneumatically connected to the machine (see par. 5.1).

Furthermore, we recommend:

To leave minimum 100 mm (3.93 in.) space around the pump in order to avoid unnatural posture or possibility

of sustaining impacts.

Not to install pump submerged into fluids or in aggressive/explosive/inflammable environments, if not

preventively provided for this purpose by the supplier.

To use gloves and safety glasses, as required in the lubrication oil safety chart.

Not to use aggressive lubricants with NBR seals. If any doubt, please contact Eng. Dept. of Dropsa S.p.A. We will

provide you with a detailed chart of recommended oils.

Not to ignore dangers to health and observe all hygienic standards.