- ページ 4

潤滑システム DROPSA 3135135のPDF ユーザー・メンテナンス・マニュアルをオンラインで閲覧またはダウンロードできます。DROPSA 3135135 14 ページ。 Chain lubrication & dispensing

6. UNPACKING AND INSTALLING Vip4chain

6.1 UNPACKING

Once a suitable location has been found to install the unit remove the unit from the packaging. No particular disposal

procedures are necessary, however packing should be disposed of in accordance with regulations that may be in force

in your area or state.

6.2 INSTALLING THE UNIT

Allow sufficient space around the unit for ease of maintenance. Install at a suitable level for refilling the oil reservoir.

Do not install in aggressive environments. Fix the unit using the two fixing holes and 6mm screws.

6.3 ELECTRICAL WIRING

Before carrying out any wiring, ensure that the correct power supply is available. Refer to the identification label on

the unit and this instruction manual.

6.4 INSTALLING THE MICROPUMPS ONTO THE BASE MODULE

Normally, you will order a unit already pre-configured with the correct number of micropump and base modules. In

the event these need to be altered or changed, the pumps can be removed by taking out the 2 fixing screws as shown

on the diagram bellow. Ensure to place the three O-Rings correctly when installing a new pump module.

6.5 ADDITING OR REMOVING A SUBBASE.

The bases must always be added or removed from the bottom one first. To add or remove a sub-base from the

Vip4chain unit

1. Disconnect power and air suppl and empty the tank (by removing the unit and pouring out the oil into a

container)

2. Disconnect the solenoid valve on the base of the unit using the three fixing screws.

3. Remove the End-plate by undoing the two fixing screws

4. Add a new sub-base (or remove the existing one) as shown in the diagram below. Ensure the Electrical

connector and O-rings are all in place before closing the sub base against either another sub-base or the end-

plate

5. Add the end-plate and the solenoid valve.

Electrical

Connector

Push-in

Fixing screws

Micropump

O-Rings

Mixing Sub

Base

Bleed screw



Threaded Insert

O-Seals



Bleed screw

Mixing Sub-Base

Plate

Fixing Screws