- ページ 12

コーヒーメーカー ELEKTRA KUPのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。ELEKTRA KUP 19 ページ。 Professional espresso coffee machines

ページを印刷する

MAINTENANCE AND CLEANING

DAILY CLEANING OF THE GROUPS AND FILTERHOLDERS

Each evening or at least once a day, clean the group shower and the filterholder gaskets with

a cloth or a sponge.

Rinse the filters and filterholders in boiling water in order to remove the fatty deposits of the

coffee. It is advisable to wash the inside of the filterholders and filters with a view to avoiding

incrustations and coffee deposits which could fall off during coffee making, forming grounds in

the cup.

DAILY CLEANING OF THE STEAM WANDS

The steam wands, used for heating drinks, must be cleaned immediately after use in

order to safeguard against the formation of incrustations that could block the holes of the

spray nozzle and also to ensure that the residue of previously heated drinks does not

deteriorate, leading to the unhygienic formation of bacteria

Externally clean with a moist sponge, the steam nozzle immediately after every milk

preparation cycle.

To clean the inside of the wand instead proceed as follows:

1) Fill a stainless steel pitcher with cold water up to at least the same level as the milk resi

duals on the wand.

2) Place the wand into the water filled pitcher.

3) Operate the steam valve by means of the joy-stick marked by symbol

boils, obtaining a complete disinfection of the wand.

WEEKLY CLEANING OF THE GROUPS

At least weekly, it is necessary clean the dispensing groups from coffee deposits with

an internal cleaning through a semi-automatic procedure guided by the machine

That procedure is to be started only with hot machine ready to use and for all the groups,

as follows:

1) Press twice in quick succession the "ENTER" button": the machine automatically enters a

state of partial operation suitable for programming.

2) The main menu appear on the display: press any of the coffee buttons marked with the

"+" sign to scroll the menu and reach the desired topic, i.e:

" GROUP 1 CLEANING " or

" GROUP 2 CLEANING " or

" GROUP 3 CLEANING "

3) Press the "ENTER" button to confirm the chosen option and to start the cleaning

procedure, displaying the following alert:

" INSTALL THE BLIND FILTER, PUT THE DETERGENT AND PRESS " ENTER "

The cleaning starts on the groups, running 10 dispensing loops of 20 seconds each one.

At the end of washing cycle is displayed the following alert:

" CLEANING FINISHED: REMOVE THE FILTER HOLDER AND PRESS "ENTER" TO MAKE RINSING "

a rinsing step will get started on the dispensing groups, divided into 30 seconds of

dispensing, 30 seconds of stop and 30 second of dispensing.

On rinse completion remove the blind filter, place the standard filter back and hook the

filterholder on the dispensing group.

until the water

4) Quit from programming by scrolling the menu pushing the "+" button until the

following alert is displayed:

" TO QUIT PRESS "ENTER", TO REPEAT PRESS "+"

press the "ENTER" button: the machine automatically resumes full operation.

4 WEEKLY CLEANING OF THE FILTERS AND FILTERHOLDERS

1) Place three teaspoons of detergent for coffee machines and approx. one litre of

boiling water in a heat-resistant container.

2) Immerse the filters and filterholders in the solution prepared and allow them to soak

for about 20/30 minutes (do not fully immerse filterholders with wood handles:

the water and detergent solution would damage the handles).

3) Rinse thoroughly under running water.

WEEKLY CLEANING OF THE DRIP TRAY

At least once a week remove the lower cup grille, remove the drip tray and clean it.

Check and clean the drain box too, removing any dregs with the aid of a teaspoon, and

then rinse it

WEEKLY CLEANING OF THE BODY

Simply use a damp (non abrasive) cloth.

Do not use alcohol or solvents to clean written or painted parts as this could damage them.

MONTHLY BOILER WATER CHANGING

Due to the fact that the boiler water is used also for the hot drinks, it is preferably to chan-

ge it completely , to clean the boiler inside, minimum once a month.

1) When the machine has heated up, i.e. displaying the following alert:

" MACHINE READY "

switch it off by pressing the button marked with the symbol

2) Operate the hot water valve by using the joy-stick marked with the symbol

after having placed a big pitcher underneath the water wand, and take off hot water

from the boiler.

3) Continue to take off the water until it will finish, until it does not more come out of the

wand.

4) Switch the machine on and wait it is ready for use, after having automatically refilled

the boiler with water.