- ページ 5

潤滑システム DROPSA MiQueL EXT PRO - iのPDF ユーザー操作およびメンテナンスマニュアルをオンラインで閲覧またはダウンロードできます。DROPSA MiQueL EXT PRO - i 14 ページ。 Air/oil modular minimal system with external pump

ページを印刷する

1. Maintenance Procedures

1lt Reservoir

TECHNICAL SPECIFICATIONS

Reservoir capacity

Air inlet pressure

Air inlet pipe

Oil outlet pipe

Pressure switch calibration

Maximum pressure switch load

Maximum electric level load

6. UNPACKING AND INSTALLATION

6.1 UNPACKING

Once the suitable location for installation has been identified, open the package and remove the unit.

Check that it was not damaged during transport or storage.

The packaging material does not require special disposal precautions as it is not in any way dangerous or polluting.

6.2 INSTALLATION

Allow a sufficient amount of space for installation, leaving a minimum perimeter space of 100 mm (3,93 in.).

Install the unit at "shoulder height" to prevent abnormal positions or the possibility of impacts.

Use the brackets with the holes (see chap. 12) to fix the unit properly. It is also possible to disassemble the brackets from their

current position and reassemble them in the prepared threaded holes for side or corner installation.

It is prohibited to use the unit if submersed in fluids or in a particularly aggressive or explosive/inflammable environment if not

previously prepared for that purpose by the supplier.

Use safety gloves or glasses as specified in the safety sheet for the lubricant.

Do not use aggressive lubricants with NBR gaskets. In the case of doubt, contact the Dropsa SpA technical office to receive a

detailed card about the recommended oils.

Do not ignore the hazards to health and comply with the health regulations.

6.3 PNEUMATIC CONNECTIONS

Before making the connection, check that the valve for the main air, the manual sliding valve and the check valves (air and oil)

are closed. Make sure that the inlet pressure does not exceed 7bar.

Use fittings and pipes that are suitable for the operating pressures, push-in connection for Ø10mm pipe.

ATTENTION: Always install a regulator filter with condensate recovery on the air inlet. Any unfiltered deposits

or sediments could irreparably damage the product.

Pressurized reservoir for MiQueL EXT (optional)

Pressure switch

Pressure gauge

1lt – 3lt

4bar ÷ 7bar [87psi ÷ 101,5psi]

Ø6mm

6bar [87psi]

Voltage free contact maximum voltage 250V

Maximum power 100W

0,2A @ 30V

Loading cap

Visible level

3lt Reservoir

Air inlet

Oil Outlet

Mounting

brackets

Reservoir

Minimum electric

level