- ページ 8

扇風機 anko FT-30MCのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。anko FT-30MC 12 ページ。 30cm bench fan

3 Assembly

3.1 Safety Grille and Fan Blade

Your Fan has been boxed unassembled to minimise packaging waste.

Each part is designed to fit together and be disassembled easily for cleaning or storage.

To assemble the safety grille and blade assembly, first take the motor assembly and

remove the 4 screws as identified.

Fit the back safety grille into position (with the handle on the back of the grille at the top)

and refit the 4 screws and tighten.

Remove the protective plastic sleeve from the motor spindle shaft and

discard. Next, rotate the motor spindle until the "flat" surface is facing up.

Slide the fan blade onto the spindle ensuring the screw is lined up with the "flat"

surface on the spindle as shown.

Push on until the end of the spindle is flush with the end of the fan blade hole, then

tighten the screw.

"Flat" surface on

Motor Spindle

Fan Blade Screw

Tighten Fan

Blade Screw

Page 8 of 12

Fan Blade hole flush

with Motor Spindle