- ページ 6

ケトル anko LD-K1035のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。anko LD-K1035 7 ページ。

anko LD-K1035 ユーザーマニュアル
* Do not fill the container with less than (0.5L) or more than (1.7L) of water. If there is not enough water in
the kettle, the appliance may overheat. If too much water is filled, the boiling water may splash out.
* Be sure that the kettle is switched off before taking it off the power base.
* If the kettle is overfilled, boiling water may be ejected and cause scalding.
* The kettle is only to be used with the base provided.
* CAUTION: Do not operate the kettle on an inclined plane. Do not operate the kettle unless the element is
fully immersed. Do not move while the kettle is switched ON.
* CAUTION: To prevent damage to the appliance, do not use alkaline cleaning agents when cleaning outside
surface, use a soft cloth and a mild detergent.
* CAUTION: Position the lid so that steam is directed away from the handle.
* WARNING: Avoid spillage on the electrical connector.
* WARNING: Misuse may cause injury.
* WARNING: The heating element surface is subject to residual heat after use.
* WARNING: Do not remove the lid while the water is boiling.
CAUTION - Material damage
* Take care that any steam escaping from the appliance cannot damage wall paper, wall cabinets or other
items. Turn the spout away from furniture and walls.
* Do not use caustic, aggressive or abrasive cleaning products for cleaning.
Keep hard items away from the appliance.
* Although the kettle is protected from boiling dry, it must never be operated without water.
* If the cut-out switch switches off the kettle to prevent overheating and boiling dry, proceed as follows:
- Take the kettle from the base.
- Allow the kettle to cool down for at least 15 minutes before refilling it with water or replacing the kettle
on its base.
* Only use the kettle with the power base provided.
* Furniture today is often coated with a wide range of varnishes and plastics and is treated with various care
substances.
Some of these products may contain substances that react adversely with the rubber feet and soften them.
Therefore, place a non-slip mat under the rubber feet of the kettle base.