- ページ 7

ケトル anko LD-K3064のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。anko LD-K3064 9 ページ。

anko LD-K3064 ユーザーマニュアル
1. Hold the lid handle and pull it up to open the lid.
2. Fill the kettle with the amount of water required.
You can check the filling level on the indicator window.
3. Press the lid down firmly to close it.
Make sure that the lid is closed properly;
otherwise the water kettle may not
switch OFF after boiling.
4. Fully unwind the power cord and run it through the cable guide channel on the power base.
5. Plug the mains cable into an earthed mains power outlet socket that is within easy reach.
6. Place the kettle on the power base.
7. Set the On/Off switch to On (I).
The control blue lamp will light up to indicate that the kettle is ON.
When the water is boiling, the kettle switches OFF automatically
and the control blue lamp will go out.
8. If you wish to stop heating the water before it boils, set the
On/Off switch to Off (0).
WARNING: Risk of scalding from hot water & steam.
* Be sure that the water kettle is switched OFF before taking it off the power base.
9. After the water has come to a boil, wait a moment, until the water has stopped simmering.
Then remove the kettle from the water base.
10. Pour the water out slowly to avoid splashing. Do not open the lid while pouring out the water.
* The sieve insert in the spout prevents any larger particles of scale being poured out.
* Do not re-boil stale water. Pour it away and refill with fresh water for boiling.
DANGER– risk of electric shock
* Remove the supply cord plug from the mains power outlet socket before cleaning the kettle.
* The power base, plug and mains cord must not come into contact with water or other liquids.
* The water container must not be immersed in water.
* The product and its parts must not be cleaned in the dishwasher.

--CLEANING AND CARE --

Lid handle
ON/OFF